Belair LH User manual

LH EXTENDED CORNER DESK SHELL
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
PARTS INCLUDED
HARDWARE INCLUDED
TOOLS REQUIRED
11X 11X 9X 1X
#2 Phillips screwdriver
ASSEMBLY INSTRUCTIONS
A B C D

LH EXTENDED CORNER DESK SHELL
2
STEP 1
Attach desk back B and large right
gable D as shown. Fasten pins and
cams.
STEP 2
Lay desk top A flat and lower back
and large gable onto top. Do not fasten
hardware until next step.
STEP 3
Attach small left gable C as shown.
Fasten all pins and cams. Lift unit right
side up and use cover caps to cover any
visible cams. C
A
B
D

RH EXTENDED CORNER DESK SHELL
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
PARTS INCLUDED
HARDWARE INCLUDED
TOOLS REQUIRED
11X 11X 9X 1X
#2 Phillips screwdriver
ASSEMBLY INSTRUCTIONS
A B C D

RH EXTENDED CORNER DESK SHELL
2
STEP 1
Attach desk back B and large left
gable D as shown. Fasten pins and
cams.
STEP 2
Lay desk top A flat and lower back
and large gable onto top. Do not fasten
hardware until next step.
STEP 3
Attach small right gable C as shown.
Fasten all pins and cams. Lift unit right
side up and use cover caps to cover any
visible cams. C
A
BD

RETURN
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
PARTS INCLUDED
HARDWARE INCLUDED
TOOLS REQUIRED
7X 7X 9X 18X 3X 1X
#2 Phillips Screwdriver #2 Robertson
ASSEMBLY INSTRUCTIONS
A B C

RETURN
2
STEP 1
Connect back B and gable C as
shown. Fasten pins and cams.
STEP 2
Lay top A upside down. Lower back
and end onto top. Fasten pins and cams.
STEP 3
Return unit right side up and use
connecting flat brackets to attach return
to adjacent unit. Use cover caps to
cover any visible cams.
A
B C

HANGING PEDESTAL
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
HARDWARE INCLUDED
TOOLS REQUIRED
8X
#2 Robertson screwdriver
ASSEMBLY INSTRUCTIONS

HANGING PEDESTAL
2
STEP 1
Remove drawers from pedestal shell. To
do so the black catches on the drawer
tracks need to be released in order to
pull the drawers out. Pull drawers out
as far as possible. Pull the left track
catch up and press the right track catch
down. Pull drawers out.
* Note - drawer handles are installed
inside out for shipping. *
STEP 2
For ease of assembly lay desk
upside down. Position pedestal shell
approximately 18mm from the front
edge of the desk to leave room for
drawer front. Screw the pedestal down
to the top as shown.
STEP 3
Screw pedestal into side of desk as
shown. Lift desk right side up.

HANGING PEDESTAL
3
STEP 4
Ensure ball bearings on tracks are
towards the front. Slide drawers back
onto tracks.