Belair W-01D S Series User manual

W-01DxxxxS
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
PARTS INCLUDED
HARDWARE INCLUDED
TOOLS REQUIRED
29X 29X 29X 2X
#2 Phillips screwdriver #2 Robertson
ASSEMBLY INSTRUCTIONS
AA
BBCCDD
EE
IF DESK IS 84” + EXTRA SUPPORT PIECES
ARE REQUIRED
H
I
Extra hardware may be included
DESK ASSEMBLY IS STEP 1

W-01DxxxxS
2
STEP 1
Connect desk top A and left gable B
as shown. Fasten pins and cams.
STEP 2
Lay back D at and lower top and gable
onto back. Do not fasten pins and cams
until next step.
A
B
D
If desk is 84” + move to STEP 3.
Move to STEP 6.

W-01DxxxxS
3
STEP 3
If desk is 84” + attach desk support gable I
Fasten all pins and cams.
I
STEP 4
Lay desk back D at and lower top and
gables onto back as shown. Do not fasten
pins and cams.
D
STEP 5
If desk is 84” + attach transaction ledge
support gable H to desk back. Fasten pins
and cams.
H

W-01DxxxxS
4
STEP 7
Assemble transaction top E Fasten pins and
cams.
E
STEP 8
See W-01S - Waterfall instructions to nish
o assembly.
STEP 6
Attach right gable C . Fasten all pins and
cams and lift unit right side up.
C

W-01Wxxxx
1
DISCLAIMER
• Two people are recommended for the assembly of this product.
• Use hardware provided and tools recommended to avoid any product faults.
• Always assemble product on a clean soft surface to avoid scratching.
PARTS INCLUDED
HARDWARE INCLUDED
TOOLS REQUIRED
3X 3X
#2 Phillips Screwdriver #2 Robertson screwdriver
ASSEMBLY INSTRUCTIONS
FG
WATERFALL ASSEMBLY IS STEP 2
4X

W-01Wxxxx
2
STEP 1
Connect waterfall top F and back G as
shown. Fasten pins and cams.
G
F
STEP 2
Remove backing from double sided tape on
top of waterfall. Position waterfall on center
of transaction top and secure waterfall with
screws through back of unit as shown. Use
cover caps to cover any visible cams and
screws.