Bennett Read Tough 15 User manual

USER
GUIDE
YLW6222
WET-DRY-BLOW VACUUMING SYSTEM

2
Thank you for purchasing a Bennett Read
Tough 15 wet & dry vacuum cleaner.
While this product is compact and light for ease of use, it is
packed with the power and technology to provide fast and
efficient cleaning. It is manufactured to the highest standards
of quality and is fully backed up by a ONE YEAR guarantee
by TEVO.
Should you need any support from us, please visit:
www.tevo.co.za or call 0861 77 88 88.

3
» Use the system only for its intended use.
» To protect against a risk of electric
shock, do not immerse any part of
the system in water or other liquids.
» Do not allow cord to touch hot
surfaces.
» Do not run appliance over cord.
» Do not operate the system with a
damaged cord or plug, or if the
appliance or any other part of the
system has been dropped or
damaged. To avoid the risk of
electric shock, do not disassemble or
attempt to repair the Tough 15.
Return the unit for examination and
repair. Incorrect reassembly or
repair can cause a risk of electrical
shock or injury and will not be
covered by the guarantee.
» Keep hair, loose clothing, fingers and
all parts of body away from openings
and moving parts.
» Do not use to pick up flammable or
combustible liquids such as gasoline or
use in areas where they may be present.
» Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
» Use extra care when cleaning on stairs.
» Do not use the Tough 15 without
the micro-particle filter in place, ,
except when vacuuming up liquids
(Refer to page 3 for operating
instructions)
When using as a Wet Vacuum take
caution not to over-fill the tank
with liquid to avoid risk of electrical
shock and damage to your Tough
10. Refer to page 3 of this manual
for tank capacity and instructions
» This appliance is intended for
household use only. Follow all user
instructions in this manual.
» Do not leave the Tough 15
plugged in when unattended.
» Unplug the electrical cord when
not in use and before servicing.
» Not intended for use by persons
(including children) with reduced
physical, sensory or mental
capabilities, or lack of experience
and knowledge.
» Do not allow to be used as a toy.
» Close attention is necessary when
used near children, pets or plants.
» Children should be supervised to
ensure that they do not play with the
appliance.
» Use only as described in this
manual. Use only manufacturer’s
recommended accessories.
» Do not pull cord, use cord as a handle,
close a door on cord, or pull cord
around sharp edges or corners.
» Turn off all controls as applicable before
unplugging from electrical outlet.
» Do not unplug by pulling on cord.
To unplug, grasp the plug, not the cord.
» Do not handle plug or vacuum with
wet hands or operate without shoes.
» Do not put any objects into openings.
» Do not use with any opening blocked.
» Keep free of dust, lint, hair and
anything else that may reduce airflow.
» Store your Tough 15 indoors in a
cool, dry area.
» Keep your work area well lit.
» Keep end of hose, wands and other
openings away from your face and body.
» Using improper voltage may result
in damage to the motor and
possible injury to the user. Correct
voltage is listed on rating label. For
operation on a 220-240V, 50/60Hz
power supply only.
» Use only identical replacement
parts.
» See instructions for Servicing of
Double-Insulated Appliances.
WARNING:
» To reduce the risk of injury from
moving parts – Unplug before
servicing.
» To reduce the risk of electric shock
– Unplug before cleaning or servicing
– Do not use outdoors
SAVE THESE INSTRUCTIONS
FOR FUTURE USE.
Not For Commercial Use.
For Household Use Only.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS
BEFORE USING YOUR VACUUM.
When using your Tough 15 basic
safety precautions should be
observed, including the following:
!
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY:
WARNING

4
Product View
1. On/Off switch
2. Blower function hose port (removable cap)
3. Motor unit
4. Cord storage hook
5. Washable and reusable
micro-particle filter
6. Dirt/water tank
7. Caster wheels
8. Vacuum function hose port
9. Locking clips
10. Integrated attachment holders
11. Detachable side storage box
ACCESSORIES:
12. Ultra-durable flexi hose
13. Hose handle with variable
airflow control
14. Three piece extension wands
15. Combination carpet
and hard floor
vacuum head
- dry use only!
16. Wet pick-up vacuum nozzle
17. Combination crevice/upholstery tool
Assembly instructions:
Your Bennett Read Tough 15 comes almost fully assembled and
requires very little set up:
1. Remove unit from packaging
2. Remove attachments from their packaging
3. Some of the packaging poses a choking risk to small children.
Dispose of the packaging responsibly. Recycle if possible
4. Before using for the first time check that all attachments listed
are included. If the unit is incomplete, return to the retailer
immediately. Take entire unit, packaging and proof of purchase
to the store where your purchase was made
5. Insert the caster wheels (7) at the bottom of the Dirt Tank (6)
into the holes provided. Ensure the wheels go in all the way
6. Attach the side storage box (11) with the 4 screws provided
1
2
3
4
7
8
9
10
11
12
13
6
5
14
17
15
16

5
Operations
Only operate your Bennett Read Tough 15 in accordance with the instruction
manual. Failure to follow these instructions will result in decreased cleaning
performance and may invalidate your guarantee.
Dry vacuuming:
Your Bennett Read Tough 15 Vacuum is perfect for vacuuming carpets, tiles,
mattresses, upholstery, curtains and car upholstery.
Setting up your Bennett Read Tough 15 for dry vacuuming:
1. Remove the motor unit (3) from the dirt tank (6) by lifting the locking clips (9)
upward
2. Ensure that the micro-particle filter (5) is securely installed in place
3. Replace motor unit (3) and clip locks in place (9)
4. Insert small end (opposite end to handle) of the flexi hose (12) into vacuum
function hose port (8)
5. Attach the 3 piece extension wand (14) to free end of flexi hose handle
6. Attach choice of cleaning head (15), (17) to free end of extension wand
7. Plug power cable into wall socket
8. Switch on unit using the power switch (1)
9. Vacuum in different directions across your surfaces to give you best results
After each cleaning session it is advisable that:
• The dirt tank be emptied and thoroughly rinsed and dried before storing
• The micro-particle filter is checked and cleaned if needed
This will ensure that the unit continues to deliver outstanding performance time & again
Wet Vacuuming:
Your Bennett Read Tough 15 can also suck up liquids* in and around your home…
Please note that the Bennett Read Tough 15 is NOT a carpet deep cleaner. Carpet
deep cleaning should be done with specialised deep cleaners.
Setting up your Bennett Read Tough 15 for wet vacuuming:
1. Remove the motor unit (3) from the water tank (6) by lifting the locking clips (9)
upward
2. Remove the micro-particle filter (5) (as explained below in the Maintenance and
Care section on the following page)
3. Replace motor unit (3) and clip locks in place (9)
4. Insert the large end of the flexi hose (12) into vacuum function hose port (8)
5. Attach 3 piece extension wand (14) to free end of the flexi hose
6. Attach wet pick-up vacuum nozzle (16) to free end of extension wand
7. Plug power cable into wall socket
8. Switch on unit using the power switch (1)
9. Vacuum wet spill / liquid from surface
10. When you are done, follow the cleaning instructions as outlined above
* Do not use to pick up boiling hot, flammable or combustible liquids
* Your Bennett Read Tough 15 is equipped with a float valve located at the bottom
of the motor unit which will partially shut off the suction as soon as the tank reaches
capacity. Immediately switch off the machine and empty the tank before continuing.

6
Maintenance and care
Blower Function:
Your Bennett Read Tough 15 has an additional function that allows you to blow
away leaves and grass that collect on your covered patio areas. Simply plug in and
blow the dirt away.
Setting up your Bennett Read Tough 15 to use the blower function:
1. Remove the motor unit (3) from the dirt tank (6) by lifting the locking clips (9)
upward
2. Ensure that the micro-particle filter (5) is securely installed in place
3. Replace motor unit (3) and lock clips in place (9)
4. Twist anticlockwise and pull to remove blower port cap (2)
5. Insert large end of the flexi hose (12) into Blower function hose port (removable
cap) (2)
6. Attach the 3 piece extension wand (14) to free end of flexi hose (optional)
8. Plug power cable into wall socket
9. Switch on unit using the power switch (1)
Emptying the Dirt Tank:
1. Disconnect flexi hose (11) from the Motor unit by grasping and twisting the end
of the hose by the Hose Port (8) and then pulling the hose outward
2. Take unit to disposal area
3. Lift locking clips (9) to unlock dirt tank
4. Lift motor unit (3) from dirt tank and place on ground
5. Lift dirt tank and empty contents into disposal area
6. Rinse Dirt tank under running water and dry
Cleaning the Filter:
It is necessary to wash the micro-particle filter (5) weekly
• To remove the micro-particle filter, turn the motor unit (3) upside down
• Grasp the locking mechanism at the bottom of the micro-particle filter (5), twist
anticlockwise and remove
• Wash the filter in warm water. You may use a mild detergent
• Allow to dry completely before replacing the filter
• Replacement micro-particle filters are available from major retail outlets
• Reassemble and store, ready to use!

7
Troubleshooting
Machine not
switching on
Problem Possible causes Remedies
1. Power cord not firmly plugged in
or not switched on at wall socket
1. Check electrical plug
Weak suction
power
1. Micro-particle filter dirty or
clogged
1. Remove and clean
micro-particle filter
as explained on page
6. It is important
to check and clean
filter regularly
2. Remove flex hose,
nozzle and extension
pipes as explained
on page 5.
Clean and check for
any obstructions
Visible dust
escaping from
the machine
while vacuuming
1. Micro-particle filter not installed
2. Micro-particle filter dirty
1. Check micro-particle
filter, situated
underneath the
motor unit
1. Clean micro-particle
filter as explained on
page 6
2. Obstruction in flex hose,
vacuum nozzle or extension
pipes
Technical Specifications:
Nominal voltage: 220-240 V AC
Nominal frequency: 50/60 Hz
Power Output : 1200 - 1400W
Dirt Tank Capacity : 15 Litres
Other maintenance or service not included in the manual should be
performed by an authorized Tevo service representative.
For any questions or concerns, contact customer care listed on page 8.

8
Consumer Guarantee
The Bennett Read Tough 15 has a one year product guarantee from
Tevo (Pty) Ltd. In the event of the unit malfunctioning, Tevo will
replace or repair, at Tevo’s option, any faulty component, free of
charge from the date of purchase by the original purchaser for one
year, any defective or malfunctioning part due to manufacturing
defect. This guarantee applies to product used for personal or
domestic use only, and specifically excludes any malfunction or
defect arising from commercial use. This guarantee does not apply
to routine maintenance components such as filters and brushes.
Damage or malfunction caused by negligence, abuse, unauthorized
repair, or use not in accordance with the User Guide is not covered.
Tevo is not liable for incidental or consequential damages of any
nature associated with the use of this product. Tevo’s liability will
not exceed the purchase price of this product.
Guarantee and Service enquiries can be made by contacting:
Tevo (Pty) Ltd
Gauteng 086 111 8386
Durban [phone]
Cape Town [phone]/9
Customer Service Help Line 0861 77 88 88
www.tevo.co.za