BIOTRONIK Reocor S User manual

Reocor S Quick Reference Guide
Output (Ampl. V)
Up to 17 V
Two second tone if amplitude is programmed below 1.0 V
Programmable V Settings
Sensitivity (Sens. mV)
1.0-20 mV
Lights will indicate pacing or sensing
Basic Pacing Parameters
Mode Fixed or Demand
Rate 30-250 ppm
Two second tone if rate is programmed above 180 ppm
9 V Battery Drawer
Up to 600 hours of use*
36 hours after battery warning
(Low Battery light blinks)
30 seconds during battery replacement
(more details on reverse side)
*
VVI, 70 ppm, 5 V, 500 Ω
Atrial Burst Functionality
60-1,000 ppm
Select the rate on the dial
When ready, press “Select burst”
followed by “Start burst”
Versatile Lead connection
Polarity configuration options
(more details on reverse side)
RF142r1 7/17/12
© 2012 BIOTRONIK, Inc. All rights reserved.

Reocor S Reference Card
Battery Details
Reocor will function if battery poles (+/-) are reversed
30 seconds of complete functionality while removing battery
to replace
Blue latch locks the battery drawer in place
Up to unlock & Down to lock
Bipolar Connection Required
If using touch-proof 2 mm unipolar plugs, you MUST insert two
per lead for appropriate function
Can be configured to work with common temporary wires, heart
wires, or IS-1 implantable leads
(Refer to the Reocor S Technical Manual for more details)
RF142r1 7/17/12
© 2012 BIOTRONIK, Inc. All rights reserved.
Reocor D picturedReocor D pictured