Bissell SPINWAVE 2240F User manual

•Press power on a fully charged unit - a full blue light will turn on
oIf only part of the light turns on and the pads spin then turn off, the machine need to
be charged (When plugged in the blue indicator light flashes and fills until fully charged, if not test a
different working outlet)
•If the pads don't spin and the light is blinking, this indicates the pads stopped spinning from:
•
oPushing down or stepping on the foot
oUsing on carpet or rugs
oUsing without pads on bare floors
•Recline machine within 10 seconds - power turns off after 10 seconds when upright to save battery
power
•Hold spray button
If it is not charging:
•Unplug machine
•Run hand along entire length of power cord, it should be smooth
•Check plug for damage
oIf either the cord (not smooth or exposed wires) or plug (prongs) are damaged, visit a BISSELL
Authorized Service Center or Contact Us

•Check to see if outlet is working:
oTest this by plugging in a cell phone charger or small appliance
oIf no power to outlet, test a different outlet in a separate room
oReset circuit breaker if needed
If machine still does not have power, contact us
If discs are wobbly:
•Check to make sure rectangular Velcro pads are not raised/out of place
oIf they are, they can be pushed back into place and should lay flat on the disc
oIf you cannot push them back to lay flat, a new disc will need to be ordered