BMC YH-600B Pro User manual

YH-600B Pro Quick Operation Manual V1.01
1 / 4
YH-600B Pro Quick Operation Manual
1. Button Function
On-Off / OK Button: Turn on/off the device, confirm adjustment.
Shift Button: Switch interfaces and options.
+
If there is no “Exit” on menu page, press and hold these two buttons
together to exit menu page.
2. Setting up the Device
(1) Wear main device on the wrist (preferentially on left wrist) like a watch, and fasten
the wrist belt and move the main device to a comfortable position.
(2) Wear and fasten the respiration effort belt around the body. Insert the effort lead
cable into the holes on the respiration kit, and hang the respiration kit on the
respiration effort belt.
(3) Make the two small open tubes on airflow cannula point towards your nostrils. Fit
the loop around your ears and then back around your neck, without pulling over
your head. Draw the cannula to a comfortable position under your chin, place
adhesive tape as indicated to help secure the cannula.

YH-600B Pro Quick Operation Manual V1.01
2 / 4
(4) Fit the airflow cannula to the connections of the respiration kit by turning it
clockwise, then insert the data connector of the respiration kit into the Flow / COM
port on the right side of the device.
(5) Insert the index finger into the pulse oximeter sensor. The finger must reach the
end of the sensor, but don’t over the end of the sensor. Insert the data connector of
the pulse oximeter sensor into the SpO2port on the top of the main device.
(6) The figure below shows what it looks like when each accessory is fitted.

YH-600B Pro Quick Operation Manual V1.01
3 / 4
3. Recording
(1) Power on device by
pressing and holding
On-Off / OK Button
for approximately
five seconds, enter the
“Record” interface.
(2) If each accessory is connected well, the
“Record” interface can be accessed. The time
notification (0:00:00) in the upper left corner of
the “Record” interface flickers. Press and hold
the On-Off / OK Button for
approximately two seconds to start recording.
Setup
Data Tools
Record
(3) Stop the recording by pressing and holding the On-Off / OK Button and Shift
Button + simultaneously approximately three seconds. Power off
device by pressing and holding On-Off / OK Button for approximately five
seconds.

YH-600B Pro Quick Operation Manual V1.01
4 / 4
4. Data Analysis
From the “Data” interface, users can view each recording data and have a look of SAHS
severity as below:
5. Operation in “Tools” Interface
From the “Tools” interface, data can be transferred via Bluetooth and erased manually. You
can also choose different languages in this inerface.
6. Important Tips
Before using the device, please read the entire user manual and memorize all
information necessary to ensure proper use of the device.
390513