Bodypoint HW100-150 Guide

Shoulder Harness Strap Guides
INSTALLATION AND USER’S INSTRUCTIONS
WARNING! Product should be installed and
tted by a qualied rehab technician.
This product is intended for mounting position-
ing harnesses. It is NOT intended for use as a
transportation safety device.
WARNING! This product should only be used
for positioning a person in a wheelchair or work
chair. It is NOT intended for use as a transporta-
tion safety device, as a personal restraint device,
or in any other application where its failure could
result in injury. Misuse of this product is
unauthorized and unsafe.
WARNING! This product carries a limited
lifetime warranty against defects in workmanship
and materials arising under normal use by the
original consumer. Contact your supplier or
Bodypoint for warranty claims.
© 2019 Bodypoint, Inc. All rights reserved. BPI104-en 2019.3
MDSS GmbH
Schiffgraben 41
D-30175 Hannover
Germany
PACKAGE CONTENTS
Package may contain one or more of the following:
• Strap Guides, 150mm or 200mm long, with fasteners
• Mounting Adapter, Small (185mm) or Large (270mm wide), with fasteners
ART NOS. HW100-150, HW100-200, HW105S, HW105L
These instructions provide important information for the safe use and maintenance of all Bodypoint
Shoulder Harness Strap Guides. Give these instructions to the user or their caregiver and review them
to ensure that they are understood.
en

Front-Pull Rear-Pull Rear-Pull with 150mm
Strap Guide Cam Buckle
INSTALLATION REQUIREMENTS
Wheelchair with a solid backrest of metal or plastic,
up to 4mm (5/32”) thick. Thicker backrests will re-
quire longer mounting screws with a minimum pullout
strength of 90kg (200lbs) (Not included in package).
POSITIONING
Seat user in wheelchair and establish correct posture
with pelvic support belt. Position strap guides
between neck and shoulder joint, approximately at
shoulder height (adjust up/down for pressure distri-
bution) Determine best strap guide orientation based
on the user’s needs.
INSTALLATION
with Mounting Adapter
1. Attach strap guides to mounting adapter using
12mm (1/2”) screws and nut plates.
2. Attach mounting adapter to the seat back using
the headrest receiver and its screws, or other
appropriate mounting hardware. (Not included in
package)
ATTACH SHOULDER HARNESS
INSTALLATION
Strap Guide only
8mm (3/8”)
5/32” (4mm) 5/32” (4mm)13 NM MAX
(115 lbf-in) 13 NM MAX (115 lbf-in)
16mm (5/8”)
en
12mm (1/2”)
1
2