BOMBAY 1850534 User manual

1850534
Adderley Cheval Mirror
Page 1 of 3 R1-5-16-03
Parts and Hardware List
A. Mirror Support Posts 2 pcs
B. Back Stretcher 1 pc
C. Mirror Frame 1 pc
D. Base Assembly 1 pc
E. Feet 4 pcs
F. Short Allen Head Bolts 4 pcs
G. Long Allen Head Bolts 6 pcs
H. Lock Washers 10 pcs
I. Flat Washers 6 pcs
J. Cast Dutch Screws 2 pcs
K. Rubber Washers 2 pcs
L. Wood Washers 2 pcs
M. Allen Head Wrench 1 pc
∗ Please make sure that you have all the parts and hardware indicated above before you begin assembly of this item.
∗ Use the hardware illustrations to determine correct piece and size.
∗ This item should be assembled on a soft surface to prevent scratching the finish during assembly.
∗ This item may require periodic tightening.

1850534
Adderley Cheval Mirror
Page 2 of 3 R1-5-16-03
Hardware Illustrations
F. Short Allen Head Bol
t
G. Long Allen Head Bolt
H. Lock Washe
r
I. Flat Washe
r
K. Rubber Washer
L. Wood Washe
r
J. Cast Dutch Screw

1850534
Adderley Cheval Mirror
Page 3 of 3 R1-5-16-03
Assemble Mirror
Parts required
A. Mirror Support Posts 2 pcs H. Lock Washers 10 pcs
B. Back Stretcher 1 pc I. Flat Washers 6 pcs
C. Mirror Frame 1 pc J. Cast Dutch Screws 2 pcs
D. Base Assembly 1 pc K. Rubber Washers 2 pcs
E. Feet 4 pcs L. Wood Washers 2 pcs
F. Short Allen Head Bolts 4 pcs M. Allen Head Wrench 1 pc
G. Long Allen Head Bolts 6 pcs
1. Attach Feet (E) Place the Base Assembly (D) upside down. Align the pre-drilled holes in the Feet (E) with the pre-
threaded holes in the bottom of the Base Assembly (D). Secure with the Short Allen Head Bolts (F), and Lock
Washers (H) using the Allen Head Wrench (M). See illustration.
2. Attach Back Stretcher (B) Insert the Back Stretcher (B) into the pre-drilled holes in the Mirror Support Posts (A).
See illustration.
3. Attach Mirror Support Posts (A) Place the Base Assembly (D) down on one side and pull the draw half-way out.
Align the pre-drilled holes in the Base Assembly (D) with the pre-threaded holes in the Mirror Support Posts (A).
Secure in place with the Long Allen Head Bolts (G), Lock Washers (H) and Flat Washers (I) using Allen Head
Wrench (M). See illustration.
4. Attach Mirror Frame (C) Place the Rubber Washers (K) over the exposed threads of the Cast Dutch Screws (J)
and insert through the pre-drilled holes of the Mirror Support Posts (A). Place the Wood Washers (L) onto the
exposed threads of the Cast Dutch Screws (J). Carefully align the pre-threaded holes of the Mirror Frame (C) with
the threads of the Cast Dutch Screws (J) and secure by turning in a clockwise direction. See illustration.