BOMBAY 1853612 User manual

1853612
Sabine Occasional Table-AM
Page 1 of 2 R2-12-13-04
Parts List
A. Top Assembly 1 pc
B. Side Assemblies 2 pcs
C. Connector 1 pc
D. Wood Caps 2 pcs
E. Allen Head Bolts 6 pcs
F. Lock Washers 6 pcs
G. Flat Washers 6 pcs
H. Allen Head Wrench 1 pc
I. Optional Allen Head Screwdriver Bit 1 pc
∗Please make sure that you have all the parts and hardware indicated above before you begin assembly of this item.
∗This item should be assembled on a soft surface to prevent scratching the finish during assembly.
* This item may require periodic tightening.
* Take care not to overtighten bolts if using supplied Allen Head Screwdriver Bit.
Hardware Illustrations
G. Flat Washer
F. Lock WasherE. Allen Head Bolt

1853612
Sabine Occasional Table-AM
Page 2 of 2 R2-12-13-04
Assembly Instructions
1. Attach Connector (C) Insert the Connector (C) into the holes in the middle of Side Assemblies (B). Note: Side of
Side Assembly (B) with label “inside” face inwards. Insert the Allen Head Bolts (E) with Lock Washers (F) and Flat
Washers (G) through the holes in the Side Assemblies (B) into the pre-threaded holes in the Connector (C). Secure,
but do not fully tighten with Allen Head Tool (H or I). See illustration.
2. Attach Side Assemblies (B) Put the Top Assembly (A) upside down on a soft surface. Align the pre-drilled holes in
the top rail of Side Assemblies (B) with the pre-threaded holes in the Top Assembly (A). Adjust and secure, but do
not fully tighten with Allen Head Bolts (E), Lock Washers (F) and Flat Washers (G) using Allen Head Tool (H or
I). See illustration.
3. Tighten all bolts at this time and cover the bolts securing the Connector (C) using Wood Caps (D).
G
A
B
C
D
EF
H
E
H
F
G
A
B
B
B
C
Illustration