BOMBAY Bordeaux Hall Chest 1883365 User manual

1883365
Bordeaux Hall Chest
Page 1 of 3 R1-10/5/02
Parts and Hardware List
A. Top Assembly 1 pc
B. Drawers 3 pcs
C. Legs 4 pcs
D. Back Panel 1 pc
E. Allen Head Bolts 8 pcs
F. Lock Washers 8 pcs
G. Flat Washers 8 pcs
H. Allen Head Wrench 1 pcs
I. Pan Head Screws 10 pcs
J. Flat Head Screws 6 pcs
K. Phillips Head Screwdriver 1 pc
∗ Please make sure that you have all the parts and hardware indicated above before you begin assembly of this item.
∗ Use the hardware illustrations to determine correct piece and size.
∗ This item should be assembled on a soft surface to prevent scratching the finish during assembly.
∗ This item may require periodic tightening.
Hardware Illustrations
E. Allen Head Bolt F. Lock Washer
G. Flat Washer I. Pan Head Screw
J. Flat Head Screw

1883365
Bordeaux Hall Chest
Page 2 of 3 R1-10/5/02
Attach the Legs
Parts required
A. Top Assembly 1 pc F. Lock Washers 8 pcs
B. Drawers 3 pcs G. Flat Washers 8 pcs
C. Legs 4 pcs H. Allen Head Wrench 1 pc
E. Allen Head Bolts 8 pcs
1 Attach Legs (C) Place the Top Assembly (A) upside down on a soft surface. Pull all the Drawers (B) out.
Align the pre-threaded holes in the Legs (C) with pre-drilled holes in the Top Assembly (A). Secure with Allen
Head Bolts (E), Lock Washers (F) and Flat Washers (G) by using Allen Head Wrench (H). See Illustration #1.
A
F
C
C
C
E
C
G
H
A
Illustration # 1

1883365
Bordeaux Hall Chest
Page 3 of 3 R1-10/5/02
Attach Back Panel
Parts required
A. Top Assembly 1 pc I. Pan Head Screws 10 pcs
B. Drawers 3 pcs J. Flat Head Screws 6 pcs
D. Back Panel 1 pc K. Phillips Head Screwdriver 1 pc
2 Attach Back Panel (D) Place Back Panel (D) into position on Top Assemlby (A). Insert the Pan Head Screws
(I) through the pre-drilled holes of Back Panel (D) and secure into the Top Assembly (A) by using Phillips
Head Screwdriver (K). See Illustration #2.
3 Secure Drawers (B). Turn the assembly upright. Slide the Drawers (B) back into assembly. Use Phillips Head
Screwdriver (K) to insert the Flat Head Screws (J) through the pre-drilled holes in the Drawers (B) towards the
outside to secure them inside the assembly. Note: The bottom drawer is different shape from the others. See
Illustration #2.
I
K
A
B
B
D
D
J
K
Illustration # 2