BOMBAY O-Linden 1885088 User manual

1885088
O-Linden Side Table
Page 1 of 2 R1-10-20-04
Parts and Hardware List
A. Top Assembly 1 pc
B. Stationary Shelf 1 pc
C. Legs 4 pcs
D. Metal Brackets 4 pcs
E. Phillips Head Screws 12 pcs
F. Allen Head Bolts 4 pcs
G. Lock Washers 4 pcs
H. Flat Washers 4 pcs
I. Allen Head Wrench 1 pc
J. Phillips Head Screwdriver 1 pc
∗ Please make sure that you have all the parts and hardware indicated above before you begin assembly of this item.
∗ This item should be assembled on a soft surface to prevent scratching the finish during assembly.
∗ This item may require periodic tightening.
Hardware Illustrations
E. Phillips Head Screw F. Allen Head Bolt
G. Lock Washer H. Flat Washer

1885088
O-Linden Side Table
Page 2 of 2 R1-10-20-04
Assembly Instructions
1. Attach Metal Brackets (D) Align the two pre-drilled holes in the Metal Brackets (D) with the two pre-drilled holes
in the Legs (C). Secure with Phillips Head Screws (E) using Phillips Head Screwdriver (J). See illustration #1.
2. Attach Legs (C) Place the Top Assembly (A) upside down on a soft surface. Align the pre-drilled holes in the
Legs (C) with the pre-threaded holes in the apron of Top Assembly (A). Secure with Allen Head Bolts (F), Lock
Washers (G) and Flat Washers (H) using Allen Head Wrench (I). See illustration #1 .
3. Attach Stationary Shelf (B) Put the item upright. Insert the Stationary Shelf (B) among the Legs (C) and align the
pre-drilled holes in the bottom of Stationary Shelf (B) with the pre-drilled holes in the Metal Brackets (D). Secure
with Phillips Head Screws (E) using Phillips Head Screwdriver (J). See illustration #2.
Illustration #1 Illustration #2