BONAIRE Winter i AU User manual

IMPORTANT
READ AND SAVE THESE INSTRUCTIONS.
Please keep this important manual in a safe place.
It is the owner's responsibility to ensure that regular maintenance is
carried out on this evaporative cooling product.

www.bonaire.com.au
Customer Care 1300 665 087
Thank you for purchasing a quality Bonaire Evaporative Portable Cooler.
We care about your safety and would ask you to spend a few minutes
reading these simple instructions before operating this product.

[ 1 ]

Safety!
Read carefully prior to attempting to assemble, install, operate or maintain the unit.
ŸRead and save these instructions. Do not throw these instructions away
ŸComplete the unit assembly before attempting to operate.
ŸInterference with and operation of this cooler in any manner not prescribed by these
instructions could cause a safety issue and WILL void any warranty.
Warnings
WARNING Operation:
ŸThis appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
ŸDo not use cooler on uneven or unstable surfaces.
ŸLock all the lockable wheels before operating cooler.
ŸDo not overfill. Use water only.
ŸDo not operate cooler with Rear Filter Panel removed.
ŸDo not insert any foreign objects or body parts into the air inlet or outlet, otherwise
bodily injury or property damage may occur.
ŸDo not use immediately adjacent to heat sources such as stoves or radiators.
ŸDo not use immediately adjacent to sources of water, such as swimming pools, hot
tubs, bathtubs, showers, sinks or other liquids.
ŸDo not operate this product near an open flame or the product may ignite and cause
fire, resulting in bodily injury or property damage.
ŸDo not operate in areas where gasoline, paint or other flammable liquids or vapours are
used or stored.
ŸDo not allow children to operate or service this cooler.
WARNING Electrical:
ŸAll electrical connections must comply with local construction and safety regulations
and be performed by qualified personnel.
ŸMake sure that the power switches are in the off position before connecting and
operating your cooler.
ŸDo not use this product with any solid- state speed control device.
ŸKeep the cord away from heated surfaces.
ŸDo not operate cooler with a damaged cord, plug or other components.
ŸDo not step on or roll over the power cord with heavy or sharp objects.
ŸDo not run the power cord under carpet or other floor covering. Arrange cord away
from traffic area and where it will not be tripped over.
ŸDo not use the power cord with an adaptor plug that converts the 3-pin plug into a 2-
prong connector.
ŸIf the power cord is damaged, it should be replaced by a service agent or qualified
personnel to avoid risk of bodily injury or property damage.
ŸRemove the plug from the electrical receptacle by pulling on the plug and not the cord.
[ 2 ]

ŸUse only qualified electricians for replacement or servicing of switches, or electrical
motors and components in this cooler.
ŸIf damaged, discard cooler or return to an authorized service facility for examination
and/or repair.
ŸAlways unplug the power cord from the wall outlet receptacle when the air cooler is
not in use, before adding water, before cleaning, before maintenance or before moving
to another location.
ŸDo not plug the cord into electric outlet with wet hands or an electric shock may result.
The same applies for unplugging.
WARNING Maintenance:
ŸNever wash the unit cabinet with a high-pressure hose. water may harm the motor and
electrical system.
ŸNever attempt to disassemble or alter the product in any way not instructed by this
manual. Shock, fire, or bodily injury may occur.
ŸDrain and clean the water tank before storage, after seasonal use and whenever the
unit is not used for a long period of time.
Stagnant water may cause bacterial growth and serious health problems.
Do not allow stagnant water to remain in the tank.
Take the cooler out from carton, Remove all
protective covers. Place the cooler in front of
an open window for effective cooling. Do not
use cooler in a closed room.
Ensure power supply is as specified for the
cooler. There should not be any spikes in
supply voltage.
Disconnect the power cord while filling the
water. As per the provision in your model, pour
water into the unit by opening the flap on the
front or rear. You may also add ice cubes for
faster cooling. Water can be poured up to the
highest point (or F) of the water level indicator.
You may keep a small container below the
over-flow hole, to avoid spillage of water on
your floor/carpet. For longer life of pump,
always operate it with sufficient water in the
tank.
Float valve facility is available in winter i model.
This feature makes provision for automatic
water filling of the cooler." Ensure proper
connection of water inlet pipe into the float
valve to avoid leakage.
Plug in to power source and switch on.
[ 3 ]
NOTE: Maximum water inlet pressure 200kPa

For optimum cooling performance, keep the
doors & windows open during cooler
operation.
1.POWER (ON/OFF) [ ]: Press the button to switch the cooler on/off. Icon will glow
with blue colour at ON position and RED colour at OFF position.
2.COOL [ ]: Press the button to switch the pump ON/OFF. Cool Icon will glow when
switched On. The Pump will start only when sufficient water is in the tank, indicated by
water icon glowing in WHITE. Low water level will be indicated by a buzzer for 5 seconds
and water icon will start blinking in red colour.
3.FAN [ ] : When started, the fan icon will glow. Press the button for High, Medium and
Low speeds. The selected speed will be indicated by glowing LED.
4.SWING [ ] : Press button to switch the swing function on/off. Swing icon will glow when
switched ON
5.TIMER [ ] : Press the button to set OFF timer to 1- 7 hours in intervals of 1 hr. Timer
icon will glow when timer is switched ON and the glowing LEDs will indicate the total
OFF time set.
* Shape and size can vary as per respective models.
1)Disconnect the power cord before servicing or maintenance.
2)Do not interfere with any of the electricals, and keep away from moving parts.
3)To clean the tank, remove drain plug. Drain out all the residual water, and push drain plug
back in firmly. Draining out of stagnant water regularly from tank is necessary to keep
your environment hygienic.
4)To clean the cooling pad, unplug the cooler; using a garden hose outside, apply low-
pressure water over the cooling pad. Depending on the surrounding environment, clean
the pad at least once or twice in a year,
[ 4 ]
+Remote Control (Batteries not included). - Open the battery compartment at the back of the
remote control and insert two new AAA dry cell batteries. Care must be taken to insert the
batteries into the correct polarity (+/-) markings shown inside the battery compartment

5)Under no circumstances, should customer open the cooler.
6)Always use clean tap water.
Loose contact at power socket/
Power socket not operating
Switch the fan ON by selecting the required speed
Call customer care help line no. 1300 665 087
Switch or Motor Malfunction
[ 5 ]
Winter i
AU
Diet 35i
AU
Diet 22i
AU
Diet 12i
AU

Product part description
Diet 12i AU / Diet 22i AU
Control panel
Back panel
Air outlet
Vertical Louvers
Water tank
Water level indicator
Castors
Power cord
[ 6 ]

Diet 35i AU
Control panel
Back panel
Air outlet
Vertical Louvers
Water tank
Water level indicator
Castors
Power cord
Castors Leg
[ 7 ]

Winter i AU
Control panel
Back panel
Horizontal Louvers
Air outlet
Water tank
Water level indicator
Castors
Honeycomb pads
Power cord
Castors Leg
[ 8 ]

CLASS II MODELS : DIET 35i AU,
DIET 22i AU, DIET 12i AU,
This marking indicates that this product should not be disposed of with
other house-hold wastes throughout the EU and other applicable
countries. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly. If you wish to
discard this product please contact your local authorities or dealer from
where it was purchased and ask for correct method of disposal.
Cooling performances depends on temperature of water used relative
humidity and ambient temperature
[ 9 ]
EARTHING
EARTHING

[ 10 ]

Diet 22iG AU
Diet 35iG AU
Diet 12i AU
[ 11 ]

[ 12 ]

[ 13 ]

CLIMATE TECHNOLOGIES
ABN 13 001418042
26 Nylex Avenue, Salisbury South Australia
5108
AUSTRALIA
Customer Care: 1300 665 087