Breezesta CI-1800 User manual

CHILL CHAT CHAIR
CI-1800
1 CI-1800 Assembly

A
B
E
H
I
ab
c d
f
C
e
F
G
D
PARTS
PART
DESCRIPTION
PART NO.
QTY.
A LH BACK LEG ASSEMBLY SA-00423 1
B RH BACK LEG ASSEMBLY SA-00424
1
C LH FRONT LEG PRT-00755 1
D RH-FRONT LEG PRT-00756 1
E SEAT ASSEMBLY SA-00429 1
F LH ARM ASSEMBLY SA-00427 1
G RH ARM ASSEMBLY SA-00428 1
H SPREADER PRT-00754 1
I BACK ASSEMBLY SA-00439 1
SA-00444 HARDWARE KIT
PART
DESCRIPTION
PART NO.
QTY.
a
#8 x 1-3/4 TORX SCREW
H-0000-S8175 4
b
5/16"X1-1/2" CHAIR BOLT H-0000-CB51615
8
c
5/16"X2-1/8" CHAIR BOLT H-0000-CB516218
6
d
DOUBLE SCREW H-0000-DS
4
e
T20 & T25 TORX BIT H-0000-CTD
1
f
6-INCH T20 TORX BIT H-0000-T20X6
1
2 CI-1800 Assembly

A
C
d
x2
1.
Start an end of a double screw (d) in the hole in the top of each leg.
Thread the opposite end of the double screw into the corresponding arm,
turning the legs clockwise to tighten, until the top of the leg is tight and
flush with the bottom of the arm. The slots/threaded inserts in the legs
should face toward the inside edge of its corresponding arm.
2.
Lay a leg/arm assembly from the
previous step on a non-marring surface.
Align the side rail holes of the Seat
Assembly (E) with the threaded inserts in
the legs. Fasten the Seat Assembly using
(2) of hardware b in the rear leg. Lift the
front leg end of the chair and fasten with
(2) of hardware c.
Repeat the process to attach the opposite
leg/arm assembly.
B
D
d
x2
Inside Edge
Inside Edge
b
c
F G
3 CI-1800 Assembly

I
b
c
H
a
5.
Stand the assembly from Step 4 upright as shown. Slide the Back Assembly I down
between the arms/seat rails. Hand tighten (1) of hardware c into each of the arm holes -
this will allow the back to pivot and align with the holes in the back rails/seat rails. Align
the holes in the back rails with the threaded inserts in the seat rails. Hand-tighten (2) of
hardware b in the two lower holes on each side. Once all bolts are in place, tighten with
a drill/driver.
3.
Fit one end of the spreader
H into the slot in one of the front
legs. This is easiest if you lay the
front of the chair face down on
a non-marring surface. Using
some outward pressure on the
opposite leg, push the spreader
into place on the opposite side
so it pops into the slot in that
leg.
4.
Fasten the spreader
using (2) of hardware a
at each end. The long
torx bit, f, should be
used to install these
screws.
4 CI-1800 Assembly