Breezesta CO-0100 User manual

REV05-02/21
COASTAL SWIVEL DINING CHAIR
CO-0100
1 CO-0100 Assembly

A B
C
D
E
a b c d e
Suggested Tools:
Drill, Plastic Mallet, 1/2" Socket Wrench
F
G
H
I
f
g
h i
PARTS
PART DESCRIPTION PART NO. QTY
A LEFT LEG ASSEMBLY SA-00083 2
B RIGHT LEG ASSEMBLY SA-00084 2
C SWIVEL SUPPORT ASSEMBLY SA-00085 1
D SEAT ASSEMBLY SA-00089 1
E ARM CONNECTOR ASSEMBLY SA-00086 2
F UNDER ARM SUPPORT PRT-00146 2
G LEFT ARM ASSEMBLY SA-00087 1
H RIGHT ARM ASSEMBLY SA-00088 1
I BACK ASSEMBLY SA-00069 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a 1/4"-10 X 3" LAG SCREW UNPAINTED H-0000-S103 4
b 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 2
c 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 12
d 1" HEX BOLT 5/16" DIA H-0000-HB1 4
e #8 X 2" TORX SCREW H-0000-S82 2
f #8 X 2-1/2" TORX SCREW H-0000-S825 4
g DOUBLE SCREW H-0000-DS 2
h T25 & T20 TORX BIT H-0000-CTD 1
i COASTAL SWIVEL ASSEMBLY-GEN 3 H-0000-SAC3 1
CO-0100 Assembly 2

T25
B
x2
A
x2
c
x8
C
T25
i
Rotate top plate slightly to allow
access to the holes in the
bottom plate of the swivel.
(Swivel at left is shown without
seat supports for clarity).
D
d
x4
i
a
x4
1.
Connect Parts A & B to Part C
using Hardware c as shown
Please read entire instructions
before beginning
2.
Attach Hardware i to the previous
assembly using Hardware a . Rotate the
top half of the swivel 45 degrees to run
screws through the bottom half.
3.
Attach Seat Assembly D to the swivel
assembly i using Hardware d .
3 CO-0100 Assembly

T20
F
f
x2
G
E
g
c
x4
D
e
b
x2
5.
R
otate Part E
clockwise until tight in
the orientation shown
4.
Attach Part E to
Part G using Hardware f
6.
Place Part F into the
pre cut slot and attach
with Hardware f
Please read entire instructions
before beginning
7.
Repeat steps 3-5 for
Parts H , E , & F
8.
Attach the two arm assemblies
to the seat base using hardware c .
9.
Attach Back Assembly I to the seat
base using hardware e , 1 per side.
Attach the Back Assembly center
support to each arm using hardware b .
3 CO-0100 Assembly