Breezesta AD-0100 User manual

REV02-8/19
SHORELINE ADIRONDACK
AD-0100
1 AD-0100 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

A
a
b
c d f
B
C
D
E
F
G
Suggested Tools:
Drill, Plastic Mallet
e
PARTS
PART DESCRIPTION PART NO. QTY
A LEFT ARM ASSEMBLY SA-00403 1
B RIGHT ARM ASSEMBLY SA-00404 1
C FRONT LEG PRT-00006 2
D UNDER ARM SUPPORT PRT-00007 2
E ADIRONDACK SPREADER SS-22.187 1
F BASE ASSEMBLY SA-00001 1
G BACK ASSEMBLY SA-00003 1
HARDWARE PACK
PART DESCRIPTION PART NO. QTY
a 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 2
b 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 6
c #8 X 2" TORX SCREW H-0000-S82 4
d DOUBLE SCREW H-0000-DS 2
e #8 X 1-1/2" TORX SCREW H-0000-S815 2
f T20 & T25 TORX BIT H-0000-CTD 1
AD-0100 Assembly 2
1-877-904-1234
www.Poly-Lumber-Furniture.com

C
d
A
D
T20
c
x2
4 .
Using Hardware c attach Part D
as shown
3.
Place Part D in pre-
cut slot as shown
2.
Rotate Part C clockwise until
tight in the orientation shown
1.
Connect Part C to Part A
using Hardware d as shown
5.
Repeat step 1-4 with Parts B,C,& D. These
assemblies will be used in step 7.
Please read entire instructions
before beginning
3 AD-0100 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

b
x4
Tip: If the seat
back is a little tight
going into the seat
base, partially
loosen 2 of the
seat screws to
allow the base legs
to open, insert the
seat back and then
re-tighten the
screws.
G
F
Tip: When installing the chair bolts in Steps
6 & 7, insert the bolt into the hole, align it
with the nut and finger-tighten the bolt a
couple of turns into the nut before driving
with a drill. This will help to reduce the risk
of cross-threading.
e
x2
b
x1
a
x1
6.
Attach Part G to Part F
using 4 of hardware b.
8.
Assemble Part E into the chair. Insert
the tenon into the slot in one leg. Then
with slight pressure on the opposing leg,
push the opposite side of Part E into its
corresponding slot. Screw in place using 2
of hardware e.
7.
Turn the back/seat assembly on it's
side. Lay one arm/leg assembly from
steps 1-5 on the back/seat assembly
and bolt together using 1 each of
hardware a & b as shown. Flip the chair
to the opposite side and repeat.
4 AD-0100 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com