Breezesta AD-0119 User manual

REV02-07/21
COASTAL ROCKER
AD-0119
1 AD-0119 Assembly

A
B
C
D
F
E
a b c d e
Suggested Tools:
Drill, Plastic Mallet
G
H
I
f g
PARTS
PART DESCRIPTION PART NO. QTY
A FRONT LEG ASSEMBLY SA-00071 2
B LEFT BACK LEG ASSEMBLY SA-00072 1
C RIGHT BACK LEG ASSEMBLY SA-00073 1
D UNDER ARM SUPPORT PRT-00146 2
E SEAT ASSEMBLY SA-00068 1
F ROCKER LEG PRT-00161 2
G LEFT ARM ASSEMBLY SA-00066 1
H RIGHT ARM ASSEMBLY SA-00067 1
I BACK ASSEMBLY SA-00069 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a #8 X 2" TORX SCREW H-0000-S82 2
b #8 X 2-1/2" TORX SCREW H-0000-S825 4
c 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 2
d 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 6
e 1/4"-10 X 3" LAG SCREW H-0000-S103 4
f DOUBLE SCREW H-0000-DS 4
g T20 & T25 TORX BIT H-0000-CTD 1
AD-0119 Assembly 2

A
B
G
f
x2
T20
b
x2
D
T25
E
d
x6
1.
Attach PartS A & B to Part G by inserting
Hardware f into the pre-drilled holes and
rotating Parts A & B clockwise, stopping
when the assembly is tight
3.
Repeat Steps 1 & 2 with
Parts A, C, D & H
2.
Attach Part D to the previous
assemblies using Hardware b
4.
Place Part E between the previous
assemblies and attach with Hardware d,
this step is made easier when done
upside down
Please read entire instructions
before beginning
3 AD-0119 Assembly

I
T25
F
x2
e
x4
unpainted
T20
T25
c
x2
a
x2
5.
Slide Part I in place and attach it using
the hardware shown
6.
Attach Parts F to the previous
assemblies using Hardware e
Back Leg Placement
Front Leg Placement
4 AD-0119 Assembly