brennenstuhl JARO User manual

7
DOperating Instructions
Mobile LED Light/Tripod LED Light
JARO
Note: Before use of the oodlight, please carefully read the operating instructions and store them
at a proper location!
TECHNICAL DATA
Protection class: I
IP class: IP 65
Nominal voltage 230 V versions: 220-240 V~ 50/60 Hz
Nominal voltage 110 V versions: 100-130 V~ 50/60 Hz
Connection line: H07RN-F 3G1,0
Power factor: see table (page 2)
These LED oodlights are suitable for indoor and outdoor lighting purposes.
OPERATION
Place the oodlight on a dry and level surface.The inclination of the oodlight is adjustable.To do
so, loosen the lateral quick release, turn the lamp head into the desired position and lock the quick
release again.
Quick-release lever
Framework
Carry handle
OPERATION
TRIPOD, LED FLOODLIGHT
The oodlight with type designation“T”is supplied with tripod.
In this connection, you must imperatively ensure sucient stability of the tripod and rm
assembly of the oodlight.
18P083 Mobiler_Stativ LED Strahler Jaro 498291 181120.indd 7 20.11.2018 13:52:41

8
DOperating Instructions JARO
Tripod for individual oodlight 20 W: extendible from 75 cm to 160 cm
Tripod for individual oodlight 30/50 W: extendible from 86 cm to 152 cm
Tripod for double oodlight 2 x 20 W: extendible from 82 cm to 142 cm
ASSEMBLY OF THE LED FLOODLIGHT ON THE TRIPOD
Loosen the locking screw (C). Fold out the feet completely.
Afterwards, re-tighten the locking screw (C).
There are two arrows at the tube. These mark the area
where the ring of the feet (1) have to be placed
to ensure sucient stability of the tripod. The
refore make sure that the ring of the feet (1)
matches insides the arrows area.
Fasten the LED oodlight by means of the locking screw (A) at the central hole of the fastening
bracket on the tripod.
To change the tripod height, loosen the tube nuts (B). Extend the tripod up to the desired height
and re-tighten the tube nuts (B).
SAFETY INFORMATION
1. Before use, always check the oodlight and the power supply line for any possible damage.
Never use the oodlight in case of any damage.
Caution! In case of a damaged oodlight or a damaged power supply line there will be a risk
of fatal injury from electrical current!
A Mounting screw
B Tube nuts
C Locking screw
1
18P083 Mobiler_Stativ LED Strahler Jaro 498291 181120.indd 8 20.11.2018 13:52:41

9
JARO Operating Instructions D
2. The external exible cable or cord of this luminaire cannot be replaced. If the cord is
damaged, the luminaire should be destroyed.
2.1. Valid for articles JARO 7000 M / JARO 7003 M / JARO 7003 CM / JARO 7002 M / JARO 7012 M.
If the external exible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualied person in order to
avoid a hazard.
3. The oodlight must be grounded properly.
4. The oodlight must not be used without properly attached sealing rings!
5. LED oodlights are extremely bright. Please never look directly into the light.
6. If the protective cover is broken, it should be replaced by an original Brennenstuhl protective
cover before further use of the oodlight.
7. Make sure that the oodlight has a safe and stable position.
Make sure that the cables are not crushed or damaged otherwise.
8. Keep the oodlight away from children. Children are not aware of the risks imposed by
electric current.
MAINTENANCE
The light source of this lamp cannot be replaced; if the light source has reached the end of its
service life, the entire lamp has to be replaced.
CLEANING
Do not use solvents, caustic cleaning agents or similar products. Only use a dry or slightly
moistened cloth for cleaning.
DISPOSAL
Dispose of electric appliances in an environmentally friendly manner!
Electric appliances must not be disposed of in household waste!
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
rules that used electric appliances should be collected separately and recycled in an
environmentally friendly manner.
For possibilities of disposal of the used appliance, please contact your local or municipal
administration.
DECLARATION OF CONFORMITY
The declaration of conformity is stored at the manufacturer’s.
Addresses
Hugo Brennenstuhl GmbH & Co. KG
Seestraße 1 – 3 · D-72074 Tübingen
H. Brennenstuhl S.A.S.
4 rue de Bruxelles ∙ F-67170 Bernolsheim
lectra-t ag
Blegistrasse 13 · CH-6340 Baar
www.brennenstuhl.com
18P083 Mobiler_Stativ LED Strahler Jaro 498291 181120.indd 9 20.11.2018 13:52:41