Brighter SMART 150 Beam Plus User manual

SMART 150 Beam +
150W Beam Moving Head with
This product manual contains important information about the
safe installation and use of this projector. Please read and follow
these instructions carefully and keep this manual in a safe place
User manual
Please read the instructions carefully before use

Thanks for your choosing our product, which adopts the latest light source-LED. It
overcomes the disadvantages of traditional light source (Such as high electricity
consumption, short life, high temperature, etc.) LED can save much energy, with
long life, high brightness, bright colours. It is the ideal product on all kinds of lighting
fields at present.
SAFTY INFORMATION
If the device has been exposed to temperature changes due to environmental changes,
do not switch it on immediately. The arising condensation could damage the device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be
earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would
be the case, replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power cord by the plug. Never pull out the plug by tugging the power
cord.
During initial start-up some smoke or smell or smell may arise. This is a normal process
and does not necessary mean that the device is defective, it should decrease gradually.
Please don’t project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance
with wall for smooth air flow, so there should be no shelter for fans and ventilation for
heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer of his service agent or a similar qualified person in order
to avoid a hazard.
to avoid a hazard.

Technical Specifications:
•Light source: 150W White LED + 24x 0.5W RGB Led Ring
•Beam angle 3 degrees
•Luminous flux: 18690Lux@5m on White Color
•Temperature controlled fans
•Thermal protection - when internal temperature is up to 70*C, the light output will be
reduced by half
•11 Colors + open wheel
•14 static + open gobo wheel
•8-facet rotation prism
•18 or 15 dmx channels
•IP 20

DMX Control:

––––