Bristan Body Jet JET2 C User manual

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care to
preserve the visible surfaces.
All surface finishes will wear if not cleaned correctly, the only safe way
to clean your fitting is to wipe with a soft damp cloth. Stains can be
removed using washing up liquid. All bath cleaning powders and
liquids will damage the surface of your fitting even the non-scratch
cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5 year
guarantee covers any defect in manufacture.
As gold and special effect finishes are softer than chromium plate,
special care must be taken when cleaning; a 3 year guarantee covers
these finishes.
NOTE: - the 5 year guarantee is invalidated if damaged by any
waterborne debris.
In the interests of continuous product development we reserve the right to alter specification
as necessary
PRODUCT CODE: JET2 C / JET3 C
TELEPHONE HELP LINE! [phone]
Bristan Limited
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
Web site: www.bristan.com
Telephone: [phone]
Facsimile: [phone]
Email: [email protected]
(FI JET2/3) (Rev. D1) (B)
Body Jet
Fitting
Instructions
& Content list
Please keep these instructions for future reference and request of
replacement parts

Body jets are intended to be used in conjunction with other products,
such as the blending valve, diverters and stopcocks from the Bristan
pick and mix ranges in order to create a system to suit your
requirements.
COMPONENTS
1. Body jet
2. Cover plate
3. Tee connector (not supplied)
INSTALLATION
Body jets should be arranged in your system to provide the necessary
spray outlets to suit the application.
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Depending on application the body jet can be panel mounted
using a backnut (not supplied) or set into the wall on rigid pipe
work. If panel mounting care should be taken to ensure
connection can be made after securing with the backnut.
3. Connect body jet to pipe work using recommended ½” BSP
connections (not provided) with thread sealing compound where
necessary.
NOTE: - Before finishing wall turn on water supplies to check
both correct system function and for leaking from
joints/connections.
4. Complete wall finish.
5. See over the page for aftercare instructions.
INSTALLATION DIAGRAM
Multiple body jets will require installation in parallel using a pressure-
balancing loop, as shown below:
MAINTENANCE
If the fitting begins to drip
1. Turn off the water supply.
2. Unscrew face plate and remove nozzle.
3. Carefully clean seating, rubber seal and nozzle.
4. Replace rubber seal, nozzle and screw on face plate.
5. Contact our help line if problem persists.