Bristan Options Bath User manual

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care
to preserve the visible surfaces. All surface finishes will wear if
not cleaned correctly, the only safe way to clean your waste is to
wipe with a soft damp cloth. Stains can be removed using washing
up liquid. All bath cleaning powders and liquids will damage the
surface of your fitting, even non-scratch cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5
year guarantee covers any defect in manufacture. As gold and
special effect finishes are softer than chromium plate, special care
must be taken when cleaning; a 3 year guarantee covers these.
NOTE: The 5 year guarantee on the valves is invalidated if damaged
by any waterborne debris.
In the interests of continuous product development we reserve the
right to alter specification as necessary.
TELEPHONE HELP LINE: 0844 701 6273
Bristan Group Ltd
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Web Site: www.bristan.com
Telephone: [phone]
Facsimile: 0844 701 6275
Email: [email protected]
(FI ON BF)(Rev. D4)(U)
Options Bath
Filler
Fitting Instructions
& Contents List
Please keep these instructions for future reference
and request of replacement parts.

WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then
the minimum distance from the outlet of the nozzle to the underside
of the cold tank should be 2 metres to ensure adequate
performance. This equates to a minimum operating pressure of 0.2
bar.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are unbalanced, i.e. hot water from the cylinder
tank / cold from the mains, approved check valves must be fitted in
the pipes. For further details contact your Local Water Authority.
CONTENTS
1. Backnut (x2)
2. Rubber Washer (x2)
3. Body (x1)
Please Note:In the unlikely event you find a part missing please
contact our Customer Service Help line on 0844 701 6273 for
immediate dispatch of part.
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Fit the mixer body to the bath securing the washers (2) and
backnuts (1) below the bath, then connect the hot and cold water
supplies.
3. Fit tap handles. Fitting varies depending on handle. Either
disassemble handle and use screw hidden under cap or secure
plastic adaptor to valve with screw and then push on handle.
NOTE: Handles must be bought separately.
4. Fully open the mixer valves, letting them run for a few minutes
and check all joints and connections for leaks.
5. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Isolate water supplies.
2. Disassemble/remove handle, unscrew retaining screw and lift
off the handle.
3. Unscrew the valve. Carefully clean seating, rubber washer
and/or ceramic disc.
4. Refit the valves, handles and tighten retaining screw. Replace
the top of the handle or handle indices.
5. If problem persists contact our helpline quoting the product
code.