Britax B-NIMBLE User manual

B-NIMBLE™ Stroller
User Guide
IMPORTANT: To ensure your child is as safe as possible, read all
instructions thoroughly before using this stroller. Store this manual for
future reference.

©2010 Britax Child Safety, Inc. All rights reserved. Printed in USA P399700_R3:08.10
This product and its components are subject to change without notice.
Warnings..2
Features..4
In.the.Box.5
Assembly..6
Operating.Instructions
Parking Brake 10
Leg Rest Adjustment 10
Recline Adjustment 11
Swivel Wheels 11
Folding the Stroller 12
Securing.Your.Child.14
Infant.Carrier.Mode
Attaching Britax Infant Car Seat Adapters                    16
Removing Britax Infant Car Seat Adapters                    16
Attaching the Infant Car Seat                              17
Removing the Infant Car Seat                             17
Rain.Cover.18
Care.and.Maintenance.19
Warranty.20
Table of Contents

2
Section Title
WARNING!
DEATH or SERIOUS INJURY can occur:
• Never leave child unattended.
• Avoid serious injury from falling or sliding out. Always use harness to
secure child.
• Do not use stroller for an infant younger than 6 months without an
infant carrier.
• Do not use stroller with a child who weighs more than 55 lbs (24.9
kg).
•
Do not use stroller with a child taller than 44 inches (111.8 cm).
• Do not overload basket – Maximum weight in basket is 10 lbs (4.5
kg). Overloading the basket may cause the stroller to become
unstable.
• Do not overload the storage pouch - Maximum weight in storage
pouch is 1 lb (0.45 kg).
• Do not overload the cup holder - Maximum weight in cup holder is
1 lb (0.45 kg).
• Always make certain that the stroller is fully open and locked before
use.
• Assembly of this stroller must be performed only by an adult.
• Do not hang or place items on the stroller handle or frame. They may
cause the stroller to become unstable.
• Children must always be restrained to prevent standing or falling out
of stroller.
• Only use Britax approved child restraints or carriers with this
stroller.
• Do not allow children to climb on or play with the stroller.
• Never use stroller on stairs or escalators.

3
Section Title
WARNING!
DEATH or SERIOUS INJURY can occur:
• To avoid entrapment or pinching, do not fold or unfold when child is
in or near stroller.
• Stroller is intended for walking speed only. Do not use while jogging,
skating, etc.
• Always set the parking brake when stroller is not moving.
• Only use accessories and replacement parts approved by Britax
Child Safety, Inc.
• Read and understand these instructions before using this product.
To ensure proper use, store this user guide in a convenient place
so it can be consulted often. Failure to follow all warnings and
instructions could result in serious injury or death.
Infant.Car.Seat.Mode
• The infant car seat adapters are ONLY compatible with Britax infant
car seat and ONLY models from 2009 or newer
• Attempting to fit them into another infant car seat can damage the
car seat or cause the car seat to fall
• Infant car seats MUST only be installed rear facing, or toward the
parent. Installing the car seat forward facing can cause the stroller to
become unstable.

4• Actual product may vary from images.
Canopy.with.Sun.Visor
Chassis.
Lock
On.right.side.
of.frame
Harness
Buckle
Leg.Rest
Front.Wheels
Rear.
Wheels
Frame.
Release.
Lever
Infant.
Car.Seat.
Adapter
Handles
Carry.
Strap
Frame.
Release.
Lever
Under-Seat.
Storage.
Basket
Swivel.
Wheel.
Locks
Features

5
B-NIMBLE.
Stroller
Canopy.with.
Sun.Visor
Front.Wheels
Rain.Cover
Cup.Holder
Infant.Car.Seat.
Receivers
Britax.Infant.Car.
Seat.Adapters
L R
In the Box

6
• Lift the chassis lock and pull
the frame apart
• Lift up on the handles and
pull them away from each
other
• Step down on the primary
frame lock pedal to lock the
stroller chassis
IMPORTANT: Ensure that the stroller
frame is locked before placing a child
in the seat
Unfolding the Stroller
WARNING: To avoid entrapment
or pinching, do not fold or unfold
when child is in or near stroller
Assembly

7
Front Wheels
Canopy
• Locate the right and left
wheels and ensure that the
swivel lock lever is locked
into place as shown before
placing wheels on stroller
• Press the wheel assembly
onto the mount at the front
of the stroller
NOTE: Pull down on wheel assembly
to ensure that it is locked
• Line up the
canopy mounts
with the brackets
on the frame and
slide them down
until they lock
into place
L
L
R
R
Assembly

8
Infant Car Seat
Receivers
• Place the infant car seat
receiver behind the stroller
frame and between the two
brackets as shown
TIP: The receiver should be pointing
upward, and the raised lines (Fig. A)
should be on the inside
• Slide the tab on the cup
holder into the slot in the
cup holder bracket
• Slide and hold the top
bracket up while closing the
receiver around the frame
and snapping it together
Cup Holder
NOTE: There is a left and right
receiver
Install as shown to ensure infant car
seat allignment
A
Assembly

9
Lowering the Infant Car
Seat Receivers
• Slide the receiver up to
release the receiver
• While holding the receiver
up, rotate to the lower
position
Assembly

10
• Step on the brake pedal on
either side of the stroller until
the wheels lock
• Lift either brake pedal to
release the brake
• Lift leg rest to raise it or
press and hold both leg rest
levers to lower
Parking Brake
Leg Rest Adjustment
Operating Instructions

11
• Lowering: From the back
of the seat, press and hold
the button on the recline
adjuster and pull away from
the seat back
• Raising: Hold the adjuster
strap and slide the recline
adjuster to the desired
position
• Move the swivel wheel lock
up to lock wheels in place
or down to allow wheels to
swivel
Recline Adjustment
Swivel Wheels
Operating Instructions

12
• Pull up on the carry strap to
release the primary frame
lock
• If infant car seat receivers
are attached you must first
rotate them to the lower
position (Page 9)
Folding the Stroller
Operating Instructions

13
• Step on the secondary
frame lock to release the
chassis
• Push the stroller forward and
continue folding until the
chassis lock engages
NOTE: You may need to compress
the stroller to engage the chassis
lock
WARNING: To avoid entrapment
or pinching, do not fold or unfold
when child is in or near stroller
Operating Instructions

14
• Unlatch the harness by
depressing the button in the
center of the buckle while
pulling the two tongues
away from the buckle
assembly
• To raise or lower the harness
height, disconnect the
buckle tongues and pull the
harness strap out from the
back of the seat
• Rethread the strap at
the desired height and
reconnect the buckle
tongues (see next page)
NOTE: Harness height should be at
or above the shoulders of the child
Securing Your Child

15
• Tighten or loosen the
harness straps by sliding
the harness adjusters up or
down
• Buckle the harness by
inserting the tongues on
the harness straps into the
buckle assembly
NOTE: Ensure the straps are
not twisted as they may become
uncomfortable for the child
To reconnect buckle tongues, line up
the two pieces and slide the upper
portion onto the track on the lower
piece
Securing Your Child

16
Attaching Britax Infant
Car Seat Adapters
• Slide each of the adapters
under the infant car seat
handle and into the shell
until they click into place
NOTE: There is a left and right
adapter and orientation should be as
shown
• Pull downward on the
adapter to ensure that it is
secure
Removing Britax Infant
Car Seat Adapters
• Pull the release lever and
slide the adapters down and
out of the infant car seat
shell
Infant Car Seat Mode

17
Attaching the Infant Car
Seat
Removing the Infant Car
Seat
NOTE: Seat back should be reclined
completely (Page 11)
• Line up the locking latches
on the infant car seat with
the sockets on the infant car
seat receivers
• Press down until the
adapters lock into place
• Lift the release levers on
both adapters and lift the
infant car seat away from the
stroller
IMPORTANT: Infant car seat must be
installed rear-facing ONLY
Infant Car Seat Mode

18
Rain Cover