Brodit 279018 User manual

4 September, 2020, www.brodit.com, © 2020 Brodit AB
Product 279018
279018 Holder with Pass-Through Connector Active holder for fixed installation. With tilt swivel. 12/24 Volt.
Active holder with pass-through connector and for fixed installation. All cables that can be used with the GPS
device can also be used with the holder, for example a TMC cable. This means that you can have both charging
and TMC connected to the GPS in the same time! When you have attached the cable to the holder it is firmly in
place and you do not have connect it manually to the device each time you put the GPS in the holder.
The holder has a straight cable with open end for fixed installation. The cable is to be connected inside the
dashboard, this gives a discreet, neat installation without cables hanging over the interior.
You can easily take the device with you when leaving the vehicle. 12/24 Volt. The product is E-
approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The
holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto a ProClip
Mounting Platform.
Charging specifications:
Input voltage: DC/10-30V
Charging voltage: DC/4.75-5.3V
Output current(Typ): 2.0A
Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection
LED charging indicator: Power input indicator(Green) , Ovp/Ocp/Output Short(Red)
Operating temperature: 0°C ~ +40°C
Storage temperature: -20°C ~ +80°C
RoHS compliant: ROHS
EAN: 7320282790189
Item no 279018 fits:
TomTom XL 30-series (For all countries)
TomTom XL IQ Routes (For all countries)
TomTom XL Live IQ Route 2nd edition (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape
provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does
not get hot!
Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1.
Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the
Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel
attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place
with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto
the attaching plate. All cables that fit the device can be attached to the holder. 4. The holder is in place.