Brodit 535481 User manual

12 June, 2014, www.brodit.com, © 2014 Brodit AB
Product 535481
535481 Holder with lock. Active holder with cig-plug. With tilt swivel. 2 keys included. Slim design with charger
integrated in the holder. Fits unit both with and without handstrap.
This holder is to be used when you want to secure your Getac Z710 and still have it easy accessable.
The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Getac Z710
without having it easy removable. The holder is made of extra strong plastic and is equipped with a lock. In order
to remove the Getac Z710 from the holder you need the key, two keys are included. Fits units both with and
without handstrap.
Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for
use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of
tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the
specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a
vehicle's dashboard is always done on the customer's own responsibility. Brodit recommends using tablets on the
car's headrest, installed onto a Brodit headrest mount.
EAN: 7320285354814
Item no 535481 fits:
Getac Z710 (US Version) (For all countries)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Place the holder onto the desired position. Screw the holder into place with the enclosed screws.
2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part
forwards so it snaps into place in the holder. Push the lock downwards and turn the key to lock the unit into the
holder.
3. To remove the device from the holder: Use the enclosed key to open the lock. Slide the locks upwards. Press
upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder
and then lift the device up and out from the holder.
4. The holder is in place.
2(2)