Brodit 711032 User manual

27 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 711032
711032 Passive holder with tilt swivel Adjustable holder. Fits for devices with and without original skin.
Keep your phone in a passive holder and you will always have it within easy sight and reach! Neat, discreet and
convenient.
Adjustable holder for use with the bare device, or the device with original skin (which is included with the phone).
Before using the holder you set the holder's width so it suits your device with or without skin. You have full access
to the camera and all buttons and outlets when the device is in the holder. You can connect a charging cable or
portable handsfree to the device when it is in the holder. The holder has a neat and discreet design which blends
well with the vehicle's interior.
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between
portrait and landscape mode. Tilts 20° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of
high grade ABS/Acetal plastic. Color: black. Made in Sweden. Attach onto ProClip Mounting Platform.
EAN: 7320287110326
Item no 711032 fits:
Huawei Mate 10 Pro (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To adjust the holder to fit for your device with or without skin: Loosen the screws on the front side of the holder
slightly. Pull out the sides of the holder slightly. Place the device in the holder and press the sides together so the
device is firmly in place. Remove the device carefully without changing the position of the sides. Tighten the
screws on the front side of the holder.
2.To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching
plate on the back.
3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw
until the holder is firmly in place, but still can be adjusted.
4. The holder is in place.