Brodit 521662 User manual

14 April, 2015, www.brodit.com, © 2015 Brodit AB
Product 521662
521662 Active holder with cig-plug With tilt swivel. With USB cable. Apple approved charging cable. Fits
devices with skin that has the following dimensions: Height: 137-144 mm, Width: 75 mm, Thickness: 2-11 mm.
Use an active holder for your Apple device on the road and you will always have a freshly charged battery! In
addition, you will always have your device within easy sight and reach. Safe, comfortable and convenient! The
holder has a neat and discreet design which blends well with the vehicle's interior. Your device is held securely in
place in an upright position for maximum cellular reception.
The holder is equipped with an Apple approved cig-plug cable for connection to the vehicle's 12 Volt socket.
When you place the device in the holder, it automatically connects to the charging unit. If you have a car with
USB interface, you can disconnect the cig-plug from the holder's cable in order to get a USB-cable to connect
directly to the USB connector in your vehicle.
Important note!
In order to be able to transmit audio files from your device through the USB-cable this feature must be supported
by the stereo in your car. This is easily tested by connecting your device to the stereo with the USB/charging
cable that comes with your device. Charging through USB works regardless.
The holder is made of Acetal plastic and has a perfect fit. It is easy to put the device into the holder, and just as
easy to take it with you when leaving the vehicle.
Fits devices with skin that has the following dimensions: Height: 137-144 mm, Width: 75 mm, Thickness: 2-11
mm. (May fit for skins thicker than 11 mm, depending on shape/design of the edges).
The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection
on the screen. You can tilt the holder 22° in each direction. Attach onto ProClip Mounting Platform.
EAN: 7320285216624
Item no 521662 fits:
Apple iPhone 6 (For all countries)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw
until the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the upper part of the device in the holder, then press the device
forwards and upwards so it snaps into place in the holder. To remove the device from the holder: Press upwards
on the lower part of the device, in the same time pull the the device out and down from the holder.
4. The holder is in place.
2(2)