Brodit Getac T800 User manual

12 September, 2021, www.brodit.com, © 2021 Brodit AB
Product 541706
541706 Holder for Locking Passive holder with spring stud locking. Fits unit both with and without handstrap.
For both standard and SnapBack battery.
This holder is to be used when you want to secure your Getac and still have it easy accessable.
The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Getac
without having it easy removable. The holder is made of extra strong plastic and is equipped with spring stud
locking. Fits units both with and without handstrap.
EAN: 7320285417069
Item no 541706 fits:
Getac T800 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part
forwards so it snaps into place in the holder.
2. Push the locking block downward to lock the unit into the holder.
3. To remove the device from the holder: Slide the locking block upwards. Press upwards on the upper part of the
holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out
from the holder.
4. The holder is in place.