BROSA Lillum Table Lamp User manual

ASSEMBLY GUIDE
Lillum Table Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Light Stand x 1
Cover x 1
Screw cap x 1
What you need
1
2
3

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 25W E14
220-240v ~ 50Hz

Step 1 Align the cover (2) to the light stand (1). Use a screw
cap (3) to tighten the cover to the light stand. Gently
screw the correct bulb (not included) into the bulb
socket.
1
2
3
Step 2 Gently turn the cover to adjust the light direction. Fix
the position by using the side knobs.

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.