BROSA Leo Arc Floor Lamp User manual

Leo Arc
Floor Lamp
A S S E M B LY GU I D E
V4

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. If the external flexible cable is damaged, it should be replaced
immediately by a certified electrician.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
MAX.60W E27
220-240V ~ 50Hz

Components
HardwareHardware
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
A x 1 B x 1
②
③
①Stand x 1
Shade x 1
Base Plate x 1
Base Weight x 1
④

Step 1 Unscrew the nut from the bottom of the stand ①with
the spanner B.
Remove the nut along with the spring washer and flat
washer.
Keep the removed parts for the following assembly.
B
①
B x 1

Step 2 Fit the base plate ③ into the rod on the bottom of
the stand followed by the base weight ④ and make
sure the rod protrudes from the bottom of the base
weight.
Fit the flat washer onto the rod followed by the spring
washer and then the nut. Tighten the nut using the
spanner B.
③
④
B
B x 1

Step 3 Unscrew the threaded rods from the connector
properly using the Allen key A but do not remove
them completely as shown in diagram below.
A x 1
A

Step 4 Insert the upper part of the stand into the connector
and make sure it sits in the connector firmly.
Tighten the rods with the Allen key A again.
A
A x 1

Step 5 Unscrew the shade ring and remove it from the bulb
holder.

Step 6 Attach the shade ② to the bulb holder.
Attach the shade ring to the bulb holder again and
screw it until the shade is tight and secure.
②