BROSA Indus Floor Lamp Large User manual

ASSEMBLY GUIDE
Indus Floor Lamp Large
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Tripod x 1
Shade screw x 1
Shade x 1
Lamp Cover x 1
1
2
4
3
Hardware
B x 1 (Plastic Washer) D x 1 (Spanner) E x 1 (Bolt) A x 2 (Washer) C x 1 (Nut)

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz

Step 1 Pull the tripod (1) legs out. Using a screwdriver
attach a bolt (E) above the tripod slide. Turn the
knob to x the slide.
1
1
E x 2

Step 2
A x 1
B x 2
C x 1
D x 1
Fit a plastic washer (A) to the top pole and align the
light shade (4) with the pole (3). Fit a washer (A), a
plastic washer (B) then a hex nut (C) to the bolt and
tighten with the spanner (D).
1
2
A
B
C
D
B

Step 3 Align the lamp cover (3) to the shade (2). Use a screw
cap (4) to tighten the cover to the shade. Gently
screw the correct bulb (not included) into the bulb
socket. Pull the handle to change the light direction.
Use the knob on the tripod to adjust height.
2
3
4

Step 4 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.