BROSA Ornis Table Lamp User manual

Ornis Table Lamp
A S S E M B LY GU I D E
V2

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 1 person.
And it's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. If the external flexible cable is damaged, it should be replaced
immediately by a certified electrician.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
MAX.25W E14
220-240V ~ 50Hz

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
Lamp Body x 1
Shade x 1
②
①

Step 1 Unscrew and detach the knob from the top of the
pole. Keep the removed knob for the following
assembly.
Step 2 Gently screw the correct bulb (not included) into the
bulb holder.
①

Step 3 Attach the shade ② to the pole and make sure the
shade parallels the bulb holder as shown in the Bird’s
Eye View below.
Attach the knob removed in Step 1 to the pole again
and tighten it to fix the shade in place.
②
Bird’s Eye View

Step 4 Check all parts are secure.
Enjoy! We hope your new Ornis Table Lamp lights up
your life.