BROSA Hirudo Floor Lamp User manual

ASSEMBLY GUIDE
Hirudo Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Pole x 4
Balance
weight x 1
Handle
screw x 2
Base x 1
Top Socket x 1
Shade x 1
What you need
12 4 5 7
3
6
8
9

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz

Step 1 Align the bottom pole (1) with the base (6) and
rmly screw them together. Continue with the
second pole (2) then the third pole (3). Align the
balance weight (5) with the end of the horizontal
pole (4) and rmly screw them together. Align the
middle hole of the horizontal pole (4) to the third
pole (3) so that the screw holes are overlaping and
x with the handle screw (7).
1
2
4
5
7
3
6

Step 2 Place the shade (9) at the end of the pole. Carefully
adjust the shade and tighten it in place with the top
socket (8). Gently screw the correct bulb (not includ-
ed) into the bulb socket. Adjust the angle of the pole
using the handle screw.
8
9

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.