BROSA Corvus Table Lamp User manual

ASSEMBLY GUIDE
v1.0
Corvus Table Lamp

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Hardware
A x 1 (Plastic Washer) D x 1 (Spanner) B x 1 (Washer) C x 1 (Nut)
Top
Pole x 1
Bottom
Pole x 1
Base x 1
132

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
220-240v ~ 50Hz
MAX 40W E27

Step 1 Step 1.1 Align the top pole (1) with the bottom pole (2)
and rmly screw them together.
Step 1.2 Attach the formed pole to the base (4). Fit a
plastic washer (A), a washer (B) then a hex nut (C) to
the bolt and tighten with the spanner (D).
A x 1
B x 1
C x 1
D x 1
Step 1.1
Step 1.2
1
2
3
A
B
C
D

Step 2 Gently screw the correct bulb (not included) into
the bulb socket.

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.