BROSA Antila Floor Lamp User manual

ASSEMBLY GUIDE
Antila Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Pole x 4
Balance
weight x 1
Handle
screw x 2
Base x 1
Top Socket x 1
Shade x 1
What you need
12 4 5 7
3
6
8
9

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 60W E27
220-240v ~ 50Hz

Step 1 Align the bottom pole (1) with the base (6) and
rmly screw them together. Continue with the
second pole (2). Align the horizontal pole’s (3)
middle hole to the second pole (2) so that the screw
holes are overlaping and x with the handle screw
(7). Align the socket pole (4) to the horizontal pole
(3) so that the screw holes are overlaping and x
with the handle screw (7). Align the balance weight
(5) with the end of the horizontal pole base (3) and
rmly screw them together.
1
2
4
5
7
7
3
6

Step 2 Place the shade (9) on top of the pole. Carefully adjust
the shade and tighten it in place with the top socket
(8). Gently screw the correct bulb (not included) into
the bulb socket. Adjust the angles of the poles using
the handle screws.
8
9

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.