BROSA Mensa Floor Lamp User manual

Mensa
Floor Lamp
A S S E M B LY GU I D E
V2

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. The external flexible cable or cord of this luminaire cannot be
replaced; if the cord is damaged, the luminaire shall be destroyed.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
MAX.60W E27
220-240V ~ 50Hz

Components
HardwareHardware
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
A x 1
①
②
Stand x 1
Base x 1

Step 1 Align the middle pole with the top pole and firmly
screw them together. Repeat this for the bottom pole.
①

Step 2 Unscrew the nut from the bottom of the stand with
the spanner A.
Remove the nut along with the washer.
Keep the removed parts for the following assembly.
A x 1
A

Step 3 Attach the base ② to the rod on the bottom of the
stand and adjust the stand carefully to make sure the
stand parallels the base as shown in the Bird’s Eye
View below.
Fit the washer onto the rod followed by the nut.
Tighten the nut using the spanner A.
A x 1
A
Bird’s Eye View
②

Step 4 Gently screw the correct bulb (not included) into the
bulb holder.

Step 5 Place the completed product in its desired location.
Enjoy! We hope your new Mensa Floor Lamp lights
up your life!