BROSA Corvus Floor Lamp User manual

ASSEMBLY GUIDE
v1.0
Corvus Floor Lamp
All manuals and user guides at all-guides.com

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Hardware
A x 1 (Plastic Washer) D x 1 (Spanner) B x 1 (Washer) C x 1 (Nut)
Top
Pole x 1
Middle
Poles x 2
Bottom
Pole x 1
Base x 1
12 43
All manuals and user guides at all-guides.com

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
220-240v ~ 50Hz
MAX 60W E27
All manuals and user guides at all-guides.com

Step 1 Step 1.1 Align the top pole (1) with a middle pole (2)
and rmly screw them together. Continue with anoth-
er middle pole (2) and nally the bottom pole (3).
Step 1.2 Attach the formed pole to the base (4). Fit a
plastic washer (A), a washer (B) then a hex nut (C) to
the bolt and tighten with the spanner (D).
A x 1
B x 1
C x 1
D x 1
Step 1.1
Step 1.2
1
2
2
3
4
A
B
C
D
All manuals and user guides at all-guides.com

Step 2 Gently screw the correct bulb (not included) into
the bulb socket.
All manuals and user guides at all-guides.com

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.
All manuals and user guides at all-guides.com