BROSA Indus Floor Lamp Medium User manual

ASSEMBLY GUIDE
Indus Floor Lamp Medium
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Middle Pole x 3
Bottom Pole x 3 Top Pole x 1 Shade screw x 1
Shade x 1
Lamp Cover x 1
What you need
1
2
4
3
6
5
Hardware
B x 1 (Plastic Washer) D x 1 (Spanner) A x 2 (Washer) C x 1 (Nut)

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz

Step 1 Align a middle pole (1) to the bottom pole (2) and
rmly screw them together. Repeat for all three legs.
Align the formed legs to the top pole (3) and rmly
screw them together.
1
1
1
2
2
2
3

Step 2 Fit a washer (A) to the top pole and align the light
shade (4) with the pole (3). Fit a washer (A), a plastic
washer (B) then a hex nut (C) to the bolt and tighten
with the spanner (D).
A x 2
B x 1
C x 1
D x 1
3
4
A
A
B
C
D

4
5
6
Step 3 Align the lamp cover (5) to the shade (4). Use a screw
cap (6) to tighten the cover to the shade. Gently
screw the correct bulb (not included) into the bulb
socket. Pull the handle to change the light direction.
Use the knob on the tripod to adjust height.

Step 4 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.