BROSA Antila Table Lamp User manual

ASSEMBLY GUIDE
Antila Table Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Pole x 3
Balance
weight x 1
Handle
screw x 2
Base x 1
Top Socket x 1
Shade x 1
What you need
134 6
2
5
7
8

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz

Step 1 Align the bottom pole (1) with the base (5) and
rmly screw them together. Align the horizontal
pole’s (2) middle hole to the pole (1) so that the
screw holes are overlaping and x with the handle
screw (6). Align the socket pole (3) to the horizontal
pole (2) so that the screw holes are overlaping and
x with the handle screw (6). Align the balance
weight (4) with the end of the horizontal pole (2) and
rmly screw them together.
1
2
4
5
3
6
6

Step 2 Place the shade (9) on top of the pole. Carefully adjust
the shade and tighten it in place with the top socket
(8). Gently screw the correct bulb (not included) into
the bulb socket. Adjust the angles of the poles using
the handle screws.
7
8

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.