BROSA Tucana Wall Light User manual

Tucana
Wall Light
A S S E M B LY GU I D E
V1

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. The external flexible cable or cord of this luminaire cannot be
replaced; if the cord is damaged, the luminaire shall be destroyed.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
2. If the glass is cracked or broken, please stop using the product.
MAX.40W E27
220-240V ~ 50Hz

Components
HardwareHardware
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
A x 2 B x 2
①
Light Body x 1
Shade x 1
②

Wall Fixings
Wood
If fixing to wood
make sure that it
isn’t chipboard as
screws can easily
pull away from the
core structure.
Brick or Masonry
Use an appropriate
wall plug provided
you are sure your
wall is sound.
Cavity Wall
Special toggle wall
plugs are needed.
Seek expert
advice.
Because of the variety of wall compositions, we can’t provide you with
appropriate wall fixings. Please identify your wall composition and
contact your local hardware store to get the appropriate fixings.
What You Need

Step 1 Before attaching, check wall for hidden pipes and
cables.
Place the light body ①against the wall. Make sure
the stem is aligned vertically. Mark location for
fixings using a pencil through the holders.
Instructions below demonstrate how to attach the light to the wall
using the provided wall plugs. However please do identify the type of
your wall and choose the appropriate wall fixings.
①

A x 2
Step 2 Remove the light body and drill holes for the wall
plugs using a drill.
Knock the plugs A into the holes using a hammer.
A
A

Step 3 Place the light body against the wall and make sure it
is aligned vertically again and fix the body in place
with the screws B.
B x 2
B
B

Step 4 Unscrew the shade ring and remove it from the bulb
holder.

Step 5 Fit the shade ② onto the bulb holder.
Attach the shade ring to the bulb holder again and
screw it until the shade is tight and secure.
②