BROSA Pictor Floor Lamp User manual

ASSEMBLY GUIDE
Pictor Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Light Stand x 1
Shade x 1
Screw cap x 1
Base x 1
What you need
1
3
2
4

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz

Step 1 Align the light stand (1) with the base (2) and rmly
screw them together. Align the shade (3) to the light
stand (1). Use a screw cap (4) to tighten the shade to
the light stand. Pull the springs and attach to the
poles. Gently screw the correct bulb (not included)
into the bulb socket.
1
2
3
4

Step 2 Gently turn the handles to change the light direction
and pole angles.

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.