BROSA Tarus Tripod Floor Lamp User manual

ASSEMBLY GUIDE
Tarus Tripod Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Hardware
A x 1 (Bolt)
Tripod x 1
Shade screw x 1
Shade x 1
Top
circular
piece x 1
Hook x 3
Bottom
circular
piece x 1
15
34
2
6

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 60W E27
220-240v ~ 50Hz

Step 1 Pull the tripod (1) legs out. Attach three hooks (2) to
the loops on the legs. Attach top (3) and bottom (4)
circular pieces so that the hooks are xed and secure
the joint with a bolt (A).
A x 1
1
1
2
3
A
4

Step 2 Place the shade (5) over the pole (1). Carefully adjust
the shade and tighten it in place with the shade
screw (6). Gently screw the correct bulb (not includ-
ed) into the bulb socket.
Use the knobs on the tripod to adjust the height of
the light.
1
5
6

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.