BROSA Apollo Wall Light User manual

Apollo Wall Light
A S S E M B LY G U I D E
V1

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety MAX.25W E14
220-240V ~ 50Hz
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. The external flexible cable or cord of this luminaire cannot be
replaced; if the cord is damaged, the luminaire shall be destroyed.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
Light x 1
HardwareHardware
A x 2 B x 2
①

Wall Fixings
Wood
If fixing to wood
make sure that it
isn’t chipboard as
screws can easily
pull away from the
core structure.
Brick or Masonry
Use an appropriate
wall plug provided
you are sure your
wall is sound.
Cavity Wall
Special toggle wall
plugs are needed.
Seek expert
advice.
Because of the variety of wall compositions, we can’t provide you with
appropriate wall fixings. Please identify your wall composition and
contact your local hardware store to get the appropriate fixings.
What You Need

Step 1
①
Unscrew the bolts attached to the base using a
Phillips head screwdriver. Remove both bolts and the
mounting bracket attached to the base. Keep the
removed bolts and mounting bracket for the
following assembly.

Step 2
Instructions below demonstrate how to attach the light to the wall
using the provided wall plugs. However please do identify the type of
your wall and choose the appropriate wall fixings.
Before attaching, check wall for hidden pipes and
cables.
Place the mounting bracket against the wall. Make
sure the bracket is aligned vertically. Mark location
for fixings using a pencil through the bracket slots.
Remove the bracket and drill holes for the wall plugs
using a drill.

Step 3
A x 2
B x 2
A
A
B
B
Knock the plugs A into the holes using a hammer.
Place the mounting bracket against the wall and
make sure it is aligned vertically again and fix the
bracket in place with the screws B.

Step 4 Align the base with the mounting bracket and make
sure the bolt holes on each part overlap. Insert the
bolts removed in Step 1 into both holes and tighten
them with a Phillips head screwdriver.

Step 5 Gently screw the correct bulb (not included) into the
bulb holder.