BROSA Aquila Table Lamp User manual

Aquila
Table Lamp
A S S E M B LY GU I D E
V1

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 1 person.
And it's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. The external flexible cable or cord of this luminaire cannot be
replaced; if the cord is damaged, the luminaire shall be destroyed.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
2. If the glass is cracked or broken, please stop using the product.
LED MAX.8W E27
220-240V ~ 50Hz

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
②
①
Shade x 1
Lamp Cup x 1

Step 1 Gently screw the correct bulb (not included) into the
bulb holder.
Step 2 Unscrew and detach the bolts attached to the lamp
cup ①.
Attach the shade ② to the lamp cup.
①
①
②

Step 3 Insert the bolts into the holes around the lamp cup
again and secure the shade in place by tightening
the bolts.

Step 4 Check all parts are secure.
Enjoy! We hope your new Aquila Table Lamp lights up
your life.