BROSA Haedus Floor Lamp User manual

ASSEMBLY GUIDE
Haedus Floor Lamp
v1.0
All manuals and user guides at all-guides.com

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Hardware
C x 1 (Plastic Washer) F x 1 (Spanner) D x 1 (Washer) E x 1 (Nut)
A x 2 (Bolt) B x 1 (Allen key)
Top
Pole x 1
Bottom
Pole x 1
Socket part x 1
Base x 1 Base weight x 1
1
24
3
5
All manuals and user guides at all-guides.com

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 40W E27
220-240v ~ 50Hz
All manuals and user guides at all-guides.com

Step 1
Step 1.1
Step 1.1
Step 1.2
Step 1.1 Align the socket pole (3) with the top pole
(2) so that the bolt hole is overlapping. Secure the
joint using a bolt (A) and the allen key (B). Continue
with the bottom pole (2) so that the bolt hole is over-
lapping and secure the joint using a bolt (A) and the
allen key (B).
Attach the formed part to the base parts (5)(6). Fit a
plastic washer (C), a washer (D) then a hex nut (E) to
the bolt and tighten with the spanner (F).
1
2
A
B
A
B
4
3
5
C
D
EF
A x 2
B x 1
C x 1
D x 1
E x 1
F x 1
All manuals and user guides at all-guides.com

Step 2 Gently screw the correct bulb (not included) into
the bulb socket. Gently pull the shade to change the
light direction.
All manuals and user guides at all-guides.com

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.
All manuals and user guides at all-guides.com