Burlington T49A CHR User manual

Parts supplied:
Ø6.0mm
6x
C
1 - 3
Tools required:
2x
12
2x 2x
1x
6x
6x
2x
4x
3
Attach the two horizontal rails to the front rail. Screw the legs into the rail.
(floor nipples)
(rubber washers)
(floor nipple washers)
65cm Basin Wash Stand T49A CHR
Please note at this
step, if you are using
the regal designer
basin stand Extension
kit (T62). Then refer
to page 3 first, and
then go onto step 4.
ST4.2 x 3.8mm

Fix each of the two brackets onto the wall using the 4
screws provided.
Ensure that the screw heads are parallel to the floor.
C
2 - 3
45
7
Check that the horizontal bracket bar is vertical
using a spirit level. Determine the final installation position and mark the
4 wall and two floor fixing hole positions in pencil.
6
Using a 6mm drill bit drill the six holes on the
marked positions (note: In the event that the wall /
floor fixings supplied being inappropriate for the
wall / floor, please source alternatives).
Fix the floor nipples
onto the floor.
There are 6 floor nipple
washers supplied.
These can be inserted
onto the floor nipples
to adjust for an uneven
floor.
89
Please refer to the BASIN INSTALLATION
INSTRUCTION for the basin installation.
Fit the two legs over the floor nipples.
The 4 Rubber washers are not recommended to use
while installing the marble basin onto the standing.
Rubber washer

Parts supplied:
C
3 - 3
Regal designer Basin Stand Extension Kit T62
2x
Please refer to the basin stand instruction for the more detail basin stand installation.
2x
Without the Extention Kit With the Extention Kit
785mm 845mm