BWI Eagle AIR-EAGLE SR PLUS 36-1200-BAT Manual

PRODUCT INFORMATION
BULLETIN
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE® SR PLUS
2.4 G
Hz
RF Transmitter
MODEL
36
-
1
2
00
-
BAT
DESCRIPTION
The AIR-EAGLE SR PLUS TX is an R.F. transmitter designed to send a
single stop command to an Air-Eagle SR Receiver from up to 600 feet
away. Any number of transmitters and receivers can be combined to
create a medium-range remote control system that operates
hazardous or hard-to-reach electrical apparatus from safe, convenient
locations. This unit has eight user-selectable network frequencies to
allow multiple systems to operate simultaneously in the same area
without interference.
INSTALLATION
DISCONNECT Power from all equipment before installation.
1. Mount the transmitter in a convenient location.
2. Install antenna onto antenna connector located on the right side on
the enclosure.
3. Install the two AA lithium batteries that were provided.
TERMINAL STRIP WIRING
1
2
3
4
5
6
7
8
9
10
E-Stop Button Pre- Wired to Input 1 C Input 2 Input 2 C Input 3 Input 3 C Input 4 Input 4 Not Used Not Used
Dimensions (with mounting plate) 6.3” L x 4.8” W x 4.3” H
CONTROLS & INDICATORS
TX LED
Illuminates red while booting up, then
extinguishes. Illuminates red while any
contact input is closed and unit is
transmitting. When this LED blinks briefly
following a transmission, the battery needs
to be replaced.
STOP Pushbutton Transmits CH1 RF “STOP” code to receiver
Inputs 2, 3 and 4 Independently transmit CH2, CH3 and CH4
codes to receiver
FREQUENCY SET-UP
The unit is shipped from the factory with all SEL2 switches in the open
positions. By default, it is operating on Frequency #1. If you wish to
change the frequency, follow the instructions on the table below.
1) Remove power from unit and take cover off.
2) Select desired frequency using table below.
3) Reattach cover and apply power. Programming is now complete.
FREQUENCY SET
-
UP
SEL1
(SW1-3)
Network
Frequency SW1 SW2 SW3
1
(default)
OPEN
OPEN
OPEN
2
CLOSED
OPEN
OPEN
3
OPEN
CLOSED
OP
EN
4
CLOSED
CLOSE
D
OPEN
5
OPEN
OPEN
CLOSED
6
CLOSED
OPEN
CLOSED
7
OPEN
CLOSED
C
L
OSED
Note
–
SW4 not used

AIR-EAGLE® SR PLUS
2.4 G
Hz RF Transmitter
MODEL
36
-
1200
-
BAT
APPROVALS
United States (FCC) OUR-XBEEPRO
Canada (IC) 4214A-XBEEPRO
Europe (CE) ETSI
SPECIFICATIONS
Power Requirements
3.0 VDC
Battery Type (2) 1.5V lithium or alkaline each, size
AA, to equal 3.0VDC nominal.
Battery Life
(Active Usage)
Approximately 3 months
Battery Life (Idle)
Up to 1 Year
Transmit Freq
uency
2.4G
H
z
S
pread Spectrum
RF Output Power
60 mW
Transmit Range Up to 600 Feet
Note: Max range figures are estimates, based on free-air terrain with limited sources of
interference. Actual range will vary based on transmitting power, orientation of
transmitter and receiver, height of transmitting antenna, height of receiving antenna,
weather conditions, interference sources in the area, and terrain between receiver and
transmitter, including, but not limited to, indoor and outdoor structures such as walls,
metal objects, trees, buildings, hills, and mountains.
Transmit Data Channels
Four Dry Contact Input
RF Networks
Eight Independent
Frequencies
Antenna Connection
TNC Female
Enclosure Polycarbonate, NEMA 4, IP66
Operating Temperature -40o F to +185o F
We
i
g
ht
Approx 1.82 lbs.
ACCESSORIES
Standard Antenna (Included):
2.4G
Hz
TNC
“Rubber Duck”
Antenna
49
-
1
201
High Gain Antennas –
Used to help achieve max range in both non line of sight and line
of sight applicat
ions.
-
Conta
c
t BWI Eagle for recommendat
i
o
ns
2.4GHz Thru
-
Hole Mount Omni Directional Antenna
49
-
2201
2.4GHz Magnet Mount Omni Directional Antenna
49
-
2202
2.4G
Hz Omni Directional Antenna
49
-
3
2
01
2.4G
Hz Yagi Antenna
49
-
3
2
02
High Quality Coax Cables –
Used to conne
c
t external high gain antenn
a
s
t
o control unit
Flex Coax Cable w/Connectors – Available
in 5’,15’,25’,30’,40’,60’,80’,100’ Lengths
49-4000-XX
(XX = # of Feet)
Bulkhead Extensions –
Used to provide an external antenna connection when mounting
con
t
rol unit inside another enc
l
o
su
re
TNC Male to TNC Bulkhead Cable Assembly
-
Available in 2’, 4’, 7’ Lengths
49-5004-X-ISO
(
(X = # of Feet)
LIMITED WARRANTY STATEMENT
BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly
used and installed, will be free from defects in material and workmanship
for a period of 1 year after date of purchase. Said warranty to include the
repair or replacement of defective equipment. This warranty does not
cover damage due to external causes, including accident, problems with
electrical power, usage not in accordance with product instructions,
misuse, neglect, alteration, repair, improper installation, or improper
testing. This limited warranty, and any implied warranties that may exist
under state law, apply only to the original purchaser of the equipment, and
last only for as long as such purchaser continues to own the equipment.
This warranty replaces all other warranties, express or implied including,
but not limited to, the implied warranties or merchantability and fitness for
a particular purpose. BWI Eagle makes no express warranties beyond
those stated here. BWI disclaims without limitation, implied warranties of
merchantability and fitness for a particular purpose. Some jurisdictions do
not allow the exclusion of implied warranties so this limitation may not
apply to you. To obtain warranty service, contact BWI Eagle for a return
material authorization. When returning equipment to BWI Eagle, the
customer assumes the risk of damage or loss during shipping and is
responsible for the shipping costs incurred.
DOCUMENT DATE: 12/9/2020 / PRODUCT REV. 6
105 Bonnie Drive
Butler, PA 16002
[phone]
Fax [phone]
www.bw
ieagle.com