Cal-Royal 2260V Series User manual

INSTALLATION INSTRUCTION FOR #2260V SERIES
FIRE VERTICAL ROD EXIT DEVICE

1-3/4” MIN
MAIN SLIDE
BOTTOM ROD GUIDE
BOTTOM ROD
STEEL BOTTOM
COVER
BOTTOM ROD
BOTTOM BOLT
CHASSISASSEMBLY
RETRACTOR
ADJ PIN
APPLY RAIL ASSEMBLY
PREPARE DOOR
APPLY TRIM+CHASSIS
APPLY COVER
ATTACH TOP AND BOTTOM CHASSIS
MARK VERTICAL AND HORIZONTAL
REFERENCE LINE ON DOOR
DON’T CUT CLOSER THAN
1-3/4” FROM LOWER PIVOT
LEVEL
RAILASSEMBLY
ATTACH TO CHASSIS WITH (2)
#6-32X3/8” PHILIPS TRUSS
HEAD MACHINE SCREWS
MOUNTING PLATE SCREWS ATTACH MOUNTING PLATETO DOOR
WITH (3) ROUND HEAD SCREWS
TIGHTAGAINST RAIL
CUT OFF AND DEBURR
VERTICAL
CHASSIS
FOR DOOR WITH STILE
CUT OFF MUST LEAVE 1/2” MIN
OVERLAP WIITH RAIL
MAIN SLIDE
LIFTARM
TOP ROD
GUIDE
TOP ROD
TOP ROD RETRACTOR
ADJ PIN
PULLMAN LATCH
TOP CHASSIS
ASSEMBLY
MOUNT TOPSTRIKE PER LOCATION IN 2ND STEP.
SCREW TOP ROD INTO MAIN SLIDE.
SLIDE GUIDE AND COVER ONTO TOP ROD AND
ASSEMBLE CHASSIS BY INSERTINGADJ PIN THRU
RETRACTORAND MIDDLE HOLE IN ROD. (SEE FIG AT
LEFT)
ADJ TOP CHASSIS MOUNTING HOLES LINE UPWITH
LOCATION MARKED IN 2ND STEP.
MOUNT BOTTOM CHASSIS SAME WAYAS TO CHASSIS
(SEE FIG AT RIGHT)
AS TO BOTTOM STRIKEAPPLICATION VARIATIONS,
PLEASE REFER TO FIG BELOW FOR THE CORRECT
MARRIAGE.
FASTEN GUIDE.
IF SHORTER ROD REQUIRED, CUT TO LENGTH AND
DRILL 1/8” O HOLE THRU.
1.
2.
3.
4.
5.
6.
THRESHOLD SURFACE STRIKE MORTISE STRIKE
1/4”
1/8”
1/8”
/
TOP DOOR STRIKE