Page 3- Manual FA01412-EN - 01/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
• The electrical cables must pass through special pipes, ducts and cable glands
in order to guarantee adequate protection against mechanical damage. • The
electrical cables must not touch any parts that may overheat during use (such
as the motor and transformer). • Before installation, check that the guided part
is in good mechanical condition, and that it opens and closes correctly. • The
product cannot be used to automate any guided part that includes a pedestrian
gate, unless it can only be enabled when the pedestrian gate is secured. • Make
sure that nobody can become trapped between the guided and fixed parts, when
the guided part is set in motion. • All fixed controls must be clearly visible after
installation, in a position that allows the guided part to be directly visible, but far
away from moving parts. In the case of a hold-to-run control, this must be installed
at a minimum height of 1.5 m from the ground and must not be accessible to
the public. • If not already present, apply a permanent tag that describes how to
use the manual release mechanism close to it. • Make sure that the operator has
been properly adjusted and that the safety and protection devices and the manual
release are working properly. • Before handing over to the final user, check that the
system complies with the harmonised standards and the essential requirements
of the Machinery Directive (2006/42/EC). • Any residual risks must be indicated
clearly with proper signage axed in visible areas, and explained to end users.
• Put the machine’s ID plate in a visible place when the installation is complete.
• If the power supply cable is damaged, it must be immediately replaced by the
manufacturer or by an authorised technical assistance centre, or in any case, by
qualified sta, to prevent any risk. • Keep this manual inside the technical folder
along with the manuals of all the other devices used for your automation system. •
Make sure to hand over to the end user all the operating manuals of the products
that make up the final machinery.
DISMANTLING AND DISPOSAL
