Campania International GFRCFT-1102 User manual

Revised October
1
7
,201
9
COMPONENTSAND PARTSLIST
Pump KitPartsList
PK800 pump (1)
Wedges(4)
#5 DrainStopper(1)
24”of ¾”clearvinyltube
*Tubinghasbeenpreassembled
GFRCFT-1102 GironaFountain-6 Foot
(3 pieces)
Toolsyou will need
Level
Thisfountainisnotcompatiblewith
afountaincover
Small Plate
18”W x 18”L x 1”H
15 lbs
Basin
72”W x 72”L x 26.25”H
486 lbs
Plate
65.5”W x 65.5”L x 1”H
126 lbs
Fountainholds
approximately220
gallonsofwater
Thisfountainiscompatiblewitha
#10 or#7Refill Device
SHOP NOW

Revised October
1
7
,201
9
ASSEMBLYINSTRUCTIONS
1.Makesureyou areassemblingyourfountainon alevelsurface
2.Unpack the providedpump.
a. NOTE:Thispump hasoneadapter, whichalsoactsas aflow valve.
3.Feed the pumpcordthrough thestandpipe inthe basin,leavingenough cordlengthinside
of thebasintoworkwiththepumpsittingflatinthebottomof the bowl.
4.Placethe ¾” clearvinyltubeoverthe threadedendof thepumpflowvalveprovidedwith
the pump.
5.Placethe pumpon thebottomofthebasin.
6.Install the largeplateensuring thattheclearvinyltubeisaccessiblethroughtheholein
the plate.
7.Placethe otherendof the ¾” clearvinyltubeinside the blue vinyltube connectedtothe
copperpipeinthe small plate.
8.Placethe small plateinthecenterof thelargeplate,on top of the basin,makingsurethat
the small plateislevel.
a.Note–Donotallowpumptorundry,asit will causedamage tothe pump
WINTER CAREAND GENERALFOUNTAIN INSTRUCTIONS
-WINTER CARE-
Fountainbowls/topsandotherfountain components,which collect water, shouldnot be left outside in the wintersince
anycomponent, whichfillswith waterandfreezesmaycrack. Likewise, componentssuch aspedestals, which remain
in abasin, filledwith water,which thenfreezes,mayalso crack orcrumble. Ideally, therefore, a fountain should always
be storedindoors orina dryprotected place such asa covered porchawayfrom the elements.However,ifafountain
must beleft outside:
(1)Remove pump, rubberstoppers, drainpipes, finials,and othersmallcomponentsforstorage indoors. Note
that stoppers ordrainpipesare removed to allow drainage in the event wateraccumulatesin anybasin.
(2)Raisefountainbase from ground with wood stripsso that base willnot freeze totheground surface.
(3)Coverorwrap thefountain with burlap orotherabsorbent material(oldblanket ortowel)and then cover
securelywith a breathable, lightlycolored material,making sure that waterwill notaccumulate inthebasin orother
fountain component and freeze.
(4)Check fountainperiodicallyto ensure that plasticissecure, and waterisnot accumulating inanyfountain
component.
-GENERALFOUNTAINTIPS-
Install fountains on alevel surface. You willneed a properlygrounded110-volt(AC only) GFCI protected
receptacle nearthefountain foryourpump. Allpumpsare submersibleand mustbe completelyunderwaterto function
properly.Test all pumpsand adjust to fulloutputpriorto assembly. Itisnot recommended that fountainsbeplaced
directlyon grass ordirt. Position the channelopening at the baseof each fountain toward the electricaloutlet to be
used sincethepump cordwillbe threaded through this opening.
Formore Campaniaproduct information visit www.campaniainternational.com
GFRCFT-1102 GironaFountain-6 Foot
(3 pieces)
SHOP NOW

CampaniaInternational-Fountain Guide
Set-up
Assembly &Installation
Afountain can bedifficult to install withoutknowing and understanding thesteps involved. To ensure your
fountain is installed properly, pleaseread ourinstructions and tips before you begin.
1. SeekProfessionalHelp: Check ifprofessionalinstallation is recommendedforyourfountain.
2. CheckFoundation: Placeyourfountain on alevelsurface.Itis recommended to place yourfountain on
concreteorahard packed gravelpad. If thebaseis levelbutsomecomponents seemoff,rotatecomponents
orusewedges to levelthem.
3. Createa DripLoop: To preventwater fromdripping down thecord and damaging theelectricalsocket,
createadrip loop by allowing thepump power cord to fall belowthewall outlet.
4. Usea GFCI Outlet: Useonly aGFCIoutletwhenrunning afountain.
Maintenance
PumpCare
Thefountain relies heavily on thequality ofthepump. Awell-maintainedpump can lastseveralyears.
1. Fully Submerge: Ensurethepump is fully submerged atall times to avoid damage.
2. Ensure Water LevelisSufficient: Check water levels regularlyas watermay evaporateovertime, and
periodically changewaterto avoid algae buildup.
3. CleanPump: Usesoap and water, orwhitevinegarand water, with asmall,softbrush to clean thepump of
debris, dirt, and algaebuildup. This should bedoneevery 2-3 months.
Surface Care
Paints and finishes may fadeover timedueto weathering. By following thesetips, you will beableto maintain
yourfountain’s surface.
1. ControlAlgaeand White Scale: Dueto waterevaporation, you may seewhiteresidueon yourfountain
surfacefromthemineralcontentin yourwatersupply. Algaecides and cleansers can help preventbuildup
thatoccurs fromminerals and hard water.
2. Protect and Refinish: Depending on thematerialofyourfountain, protectants and sprays may prolong the
appearanceofthesurface. Paintand refinishing kits can beusedfortouch-up.
Winter Care
Caststonecan expand and contractin differenttemperatures/humidity levels. If thetemperature falls below
32°Forhumidity levels changedrastically, followthesteps belowto protectyourfountain.
1. Bring Inside: If possible, bring youroutdoorfountain insideforthewinter.
2. Store inDry Location: If unableto bring inside, store yourfountain in adry and covered location.
3. Bring Components Inside: Moveall internalcomponents (stoppers, tubing, lights, pump, etc.)inside.
A pump can stayin a fountain for thewinter, butifyou chooseto leaveit in, it mustbecompletelydryand
insulated with plasticbags and towelto ensureit stays dry. However it is recommended to bring it inside.
4. Completely Drain: Itisimportantto preventwater fromaccumulating anywhere,as freezing and thawing
ofwater cancausepumpdamageand causecracksto formin yourfountain.Removethedrain plugs.
5. Elevate Fountain: Fountains may freeze to theground and causecracking in thebaseifleftoutsidein the
winter.Ifunableto store insideorin adry coveredlocation, try to raiseyourfountain aboveground.
6. Cover Fountain: Contactyourretailer to find therightsize cover foryourspecificfountain. There are four
differentsizes. Whencovering, makesurethefountain is tautso thatno snoworwatercan poolin the
cover. Pull thestring to tighten theopening ofthecover around thefountain.
SHOP NOW

Troubleshooting
PumpNotWorking
When operating thepump forthefirsttime, it cantakeafewminutes beforewater begins to flowproperly. Ifit
is still notworking after afew minutes, pleasefollowourtroubleshooting tips below.
Beforetroubleshooting, UNPLUG YOUR PUMP.
1. SubmergePump: Ensure yourpump is fully submerged in wateratall times to avoid pump damage.
2. ManualCheck: If thepump cover is removable,try removing thecoverto access theimpeller area.Turn
therotorto ensure it is notbroken orjammed.
PumpNoise
Somesound fromthepump may benormal, butyou can followthesetips to reduce sound orresolveabnormal
noises.
1. SubmergePump: Ensure yourpump is fully submerged atall times and clean ofdebris, dirtand algae
buildup.
2. CheckLocation: You may hear thevibration ofthepump touching thesidewalls ofthefountain. Make
sure thepump is only touching thebottom.
3. CheckFlowRate:Too lowofaflowratemightcausespews orburps.
Water FlowRate
Somefountains comewith adialorvalveto adjusttheflowrate, butifyou do nothavethis option orifyou are
still unsatisfied with yourflowrateafter changing thesettings, check outourtips below.
1. AdjusttheWater Level: Insufficientwater levels can affectwater intakeby thepump. Check thefountain
instructions to ensure theappropriatewater capacity foryourfountain.
2. CheckforKinks: Check to makesure thetubing is notkinked. Kinks in thetubing can sloworhalt the
flowofwater.
3. ClamptheHose: To slowthewater flow, try clamping thehosewith ahoseclamp orazip-tie.
Splashing
Having troublewith splashing?Somesplashing isinevitable, especially when you firstturn on yourfountain,
butifyou are experiencing excessivesplashing, try ourtroubleshooting tips below.
1. AdjusttheWater Level: Ensure thepump is fully submerged, butavoid overfilling yourfountain.
2. AdjustFlowRate: If yourpump includes adialorvalveto adjusttheflowrate, try changing thesettings to
see ifit affects splashing.If yourpump is notadjustable, check ourFlowRatesection to learn aboutother
ways to changetheflowrate.
3. AdjustPosition: Try arranging stones orplacing asplash guard, atthefountain base. You can also place a
screen in thebasin.
Leaking
If yourfountain is leaking, check thesequick tips on howto fix it.
1. AdjusttheWater Level: Yourfountain may leakifit is too full.
2. CheckTubing: Check thatthetubing is attachedcompletely and correctly.
3. CheckStopper: Ensure stopper is completely seated in thefountain. You can also use100%pureclear
siliconeto ensure apropersealis achieved.
4. Cracking: Yourfountainmay becrackedfromimproper winter care;see Winter Care in Maintenance Tips.
SHOP NOW