Canon PFI-101 User manual

instruction for Canon PFI-101/102/103/105
1. Conduct Part Check :
1.1). Lock for cover x 1
1.2) chip set holder x 1
1.3). chip set sliding plate x 1
1.4). ink refill hole plug x 1
2. After refill ink, insall the plug on the ink refill hole, the the ink will not flow out from the
cartridges
3. Install the chip set and chip set holder into cartridge as the picture show you as below.
Before intall the cartridge into the printer , please cancel the ink level detection in setup
button.

4. Install the chip set sliding plate, then it will fix the chip set holder as the picture.
5. it is easy to install cartridge into printer. Use the lock for cover in the right place as the
picture show as below.
Caution：Refill the ink when the ink lower because the ink level detection
have been cancel.
How to cancel the ink level detection function
1. When you install cartridge into printe and turn on the power switch, the printer screen will show
the information: Can not correctly detect the remaining ink amount, check the ink
cartridge. Please press right button one time.
2. the printer screen will show the information: please check: 1.check 2.information. please choose
“2 information”and press “OK”button.
3. the printer screen will show the information: Installed ink cartridge was exhausted. As the ink
remaining amount is unknown, so the printer to stop the action. Please press right

button one time.
4. the printer screen will show the information: If you want to continue printing, you need to cancel the
detection function of remaining ink level. Please press right button one time.
5. the printer screen will show the information: Cancel the function？1.no 2.yes. please choose “2 yes”and
press “OK”button.
6. the printer screen will show the information: Make sure the ink cartridge with ink, then cancel
the detection function of remaining ink level. Please press right button one time.
7. the printer screen will show the information: if supply the ink and occur fault, Canon is not
responsible for this. Please press right button one time.
8. the printer screen will show the information: cancel the detection function of remaining ink level.
Preservation of historical and then execute it? Please press right button one time.
9. the printer screen will show the information: YES OR NO? 1.NO 2.YES. please choose “2 yes”and press
“OK”button.
10. it is ok.