Canon CREATIVE PARK Paper Copter User manual

Never aim it at another person.
Play with it in a park or other open area. Be careful of the sharp corners when playing.
Do not swing it around, or run with it in your hand.
Assembly Instructions
Tools
1. Carefully cut out the parts.
2. Fold along the dotted lines, making mountain
or valley folds as indicated.
3. Attach the glue spots on each part together.
4. Glue the parts together, and you're done.
*Please read the Assembly Instructions
carefully before you begin.
Scissors, Glue (We recommend quick-drying paper glue),
String ( about 70cm )
How to assemble your model neatly
Scoring along the fold lines in advance with a dried
up pen or a ruler with slightly sharp corners will result
in a neater model.
*Be careful not to press too hard as the paper may tear.
Notation Key
Scissors line Mountain fold
Cut in line Valley fold
Glue spot
Caution
Keep scissors and glue away from small children.
Be careful not to cut your fingers when using scissors.
Cautions for playing
Paper Copter

Cut out the parts
Glue
Glue
Glue
Once the glue is completely dry,
cut out the part by following
the scissors line on the front.
For other parts, simply cut them out
along the scissors lines.
Assembling the propeller
Fold the parts you have cut out. Attach the propeller parts you have curved
into a ring shape.
Fold along the fold line and
glue together at the back.
Assembling the shaft
Put the part face up on the edge of a table
and roll it while applying pressure,
to give the part a curve.
Fold the edge to make a triangular prism,
and then roll it up into a stick
(about 5mm in diameter).
Finally, glue down the end
so that it doesn't get unraveled.
Assembling the paper copter
Paper Copter /
Assembly Instructions

Cut out the shaft parts and
glue the halves together at the back.
Attach the shaft parts
to the tip of the shaft.
View from above
Glue the string firmly
so it doesn't come off.
Put glue at the start and
end to attach the piece.
Attach the string (about 70cm)
and stopper to the shaft.
Assemble the shaft holder, and insert the shaft
Glue
Glue
Cut out the shaft holder parts and
glue the halves together at the back.
Attach the shaft holder
into a cylinder shape. Insert the shaft into the shaft holder,
and pull the string out through the hole.
Finally, attach the tag
to the end of the string.
Grab it with a finger, and pull it out.
How to fly your paper copter
Gently hold down the string with your thumb
so that is doesn't get tangled up inside,
and rotate the shaft clockwise
to wrap the string around it.
Set the propeller on the shaft, and swiftly pull the string.
If it doesn't fly well, try adjusting the speed
you pull the string with or the amount of strength you use.
Face the side
with the circle up.
Rather than holding
just the tag, hold the string
as well and pull.
Paper Copter /
Assembly Instructions
Attaching the shaft parts and string

Propeller
Shaft parts
Tag
Paper Copter / Pattern

Shaft holder
Shaft
Stopper
Paper Copter / Pattern
Propeller parts